NEC Display Solutions
NEC Display Solutions NP21LP Projector Lamp 230W 3000 Hrs
A 230 W UHP projector lamp rated for 3,000 hours, supplied as a complete module for quick fitting
- TypeProjector Lamp
- Wattage230W
- Lamp Life3,000 Hrs.
- Ready to install with pre-assembled housing
- 230W UHP bulb matches original brightness
- 3,000-hour lamp life supports extended use
- ISO 9001 quality checks on every unit
- Compatible with NEC NP-PA600X projector
Replacement lamp for NEC projectors
The NEC NP21LP is a 230W projector lamp module supplied as a complete bulb-and-housing assembly. It is built for users who need a direct, ready-to-install replacement for the original lamp in compatible NEC projectors. The unit arrives new and pre-assembled, removing the need for separate bulb handling or alignment.
OEM Ushio 230W module upgrades compatible lamps
This module uses a new Ushio UHP 230W bulb inside the original housing, matching the factory light source rather than a third-party compatible version. The change is worthwhile when colour accuracy, ignition reliability and rated 3,000-hour life must match the projector’s original specifications. It replaces lamps that have dimmed, flicker or show end-of-life warnings.
Rated 3,000 hours at 230W with ISO 9001 checks
Each lamp is tested for beam performance, ignition voltage, run-time and connections under ISO 9001 quality controls. The 230W rating and 3,000-hour life define the practical operating window; exceeding either reduces output and risks premature failure. Projectors without dynamic power management will run the lamp at full wattage continuously.
Highlights
- Ready to install with pre-assembled housing
- 230W UHP bulb matches original brightness
- 3,000-hour lamp life supports extended use
- ISO 9001 quality checks on every unit
- Compatible with NEC NP-PA600X projector
Specifications
| Brand | NEC |
|---|---|
| Type | Projector Lamp |
| Wattage | 230W |
| Lamp Life | 3,000 Hrs. |
Questions about this item
Which NEC projectors accept the NP21LP 230W lamp module?
The NP21LP lamp module is built for the NEC NP-PA600X projector and fits the same housing used in that model.
What is the correct way to seat the NP21LP housing so the projector recognises the new lamp?
Align the housing guides, press firmly until the connector clicks, then reset the lamp timer in the projector menu — skipping the timer reset is the step most users miss.
How often should the NP21LP 230W lamp be replaced under normal use?
The lamp is rated for 3,000 hours; plan replacement when the projector warning appears or image brightness drops noticeably.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



