NEC Display Solutions
NEC Display Solutions NP17LP Projector Lamp 265WNEC Display Solutions NP17LP Projector Lamp 265W
A 265W replacement projector lamp module with a fully assembled bulb and housing, offering 3,000 hours normal or 3,500 hours economy life for easy installation
- TypeProjector Lamp
- Wattage265W
- Lamp Life3,000 (Normal) - 3,500 (Economy) Hrs.
- Genuine 265W UHP lamp delivers reliable brightness
- Ready-to-install module with housing saves setup time
- Up to 3500 hours life in economy mode
- Manufactured to ISO 9001 quality standards
- Compatible with NEC NP-P420X projector series
Genuine NP17LP replacement lamp
The NEC NP17LP is a 265W UHP projector lamp module supplied as a complete bulb-and-housing assembly for direct installation. It is built for owners of compatible NEC projectors who need a factory-specification light source without separate handling of the bare bulb.
ISO9001 manufacturing and ready-to-fit housing
Each unit is produced to ISO9001 quality standards and undergoes checks for beam performance, ignition, voltage, connections and run-time. The pre-assembled housing eliminates alignment steps, so the lamp can be swapped in minutes during routine maintenance.
265W output with 3,000- to 3,500-hour rated life
The lamp delivers 265W and is rated for 3,000 hours in normal mode or 3,500 hours in economy mode. Buyers whose projectors demand a different wattage or significantly longer rated life should verify compatibility before ordering.
Highlights
- Genuine 265W UHP lamp delivers reliable brightness
- Ready-to-install module with housing saves setup time
- Up to 3500 hours life in economy mode
- Manufactured to ISO 9001 quality standards
- Compatible with NEC NP-P420X projector series
Specifications
| Brand | NEC |
|---|---|
| Type | Projector Lamp |
| Wattage | 265W |
| Lamp Life | 3,000 (Normal) - 3,500 (Economy) Hrs. |
Questions about this item
Does the 265W UHP lamp run on a standard projector power interface?
Yes, the 265W UHP lamp is designed for the projector's standard lamp power interface and draws its rated wattage directly from the unit.
What physical space does the NP17LP module need inside the projector?
The NP17LP module is a fully assembled bulb and housing unit built to the exact form factor of the original lamp, so it fits the existing lamp compartment without modification.
How is the lamp module installed and what step is often missed?
Power off and unplug the projector, let it cool, open the lamp cover, remove the old module by its handle, insert the new NP17LP until it seats firmly, replace the cover, then reset the lamp hour counter in the menu.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



