NEC Display Solutions
NEC Display Solutions M350XG projector lamp 230W 4000 hrs
A 230 W projector lamp rated for 4,000 hours, supplied as a complete module for quick replacement
- TypeProjector Lamp
- Wattage230W
- Lamp Life4,000 Hrs.
- Ready to install with pre-assembled housing
- 230W Ushio NSHA bulb delivers specified brightness
- Rated 4000 hours lamp life for extended use
- Manufactured to ISO 9001 quality standards
- Compatible with NEC M350XG projector model
NEC M350XG replacement lamp module
The NEC M350XG lamp module is a 230 W replacement unit built with a new Ushio NSHA bulb inside a complete housing. It arrives fully assembled so technicians can swap it into compatible NEC projectors without additional tools. The lamp is rated for 4,000 hours of operation under normal use. Each unit is produced under ISO 9001 quality controls and tested for ignition, voltage and run-time consistency.
Suits NEC projector owners needing a direct swap.
This module suits owners of NEC projectors that accept the NP16LP lamp who want a ready-to-install OEM-grade replacement with a genuine Ushio bulb. It is not for users of projectors from other manufacturers or for models that require a different lamp code or wattage. Buyers who need a bare bulb without housing or a lower-cost compatible alternative should look at other listings.
230 W Ushio NSHA bulb rated for 4,000 hours
The deciding specification is the 230 W Ushio NSHA bulb rated for 4,000 hours, which determines brightness, heat output and replacement interval. Matching this wattage and lamp-life figure to the projector's requirements confirms compatibility. No other specification in the data overrides this single compatibility key.
Highlights
- Ready to install with pre-assembled housing
- 230W Ushio NSHA bulb delivers specified brightness
- Rated 4000 hours lamp life for extended use
- Manufactured to ISO 9001 quality standards
- Compatible with NEC M350XG projector model
Specifications
| Brand | NEC |
|---|---|
| Type | Projector Lamp |
| Wattage | 230W |
| Lamp Life | 4,000 Hrs. |
Questions about this item
Does the NP16LP housing match the M350XG projector mount?
The lamp module is a fully assembled bulb and housing built to the NP16LP specification for direct fit in the M350XG projector.
Which step do installers most often miss when fitting the lamp?
After sliding the module in, the retaining screw must be tightened and the lamp-hour counter reset through the projector menu so the 4,000-hour timer starts correctly.
When will the Ushio NSHA 230W bulb need replacement?
The lamp is rated for 4,000 hours of typical use; plan to replace the module once the projector’s hour counter approaches that figure.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



