NEC Display Solutions
NEC Display Solutions LT30LP 220W projector lamp
A 220 W replacement lamp module with a new Philips NSH bulb and housing, ready to install and rated for 2 000 hours normal or 5 000 hours economy use
- TypeProjector Lamp
- Wattage220W
- Lamp Life2,000 (Normal) - 5,000 (Economy) Hrs.
- Ready to install with pre-assembled bulb and housing
- 220W NSH lamp delivers reliable brightness
- Up to 5,000 hours lamp life in economy mode
- 2,000 hours standard life for everyday use
- Manufactured to ISO9001 quality standards
Ready-to-install NEC LT30LP lamp module
This 220 W replacement lamp ships as a complete bulb-and-housing assembly for NEC projectors that use the LT30LP module. It arrives new and fully assembled so you can swap it in without handling a bare burner or aligning reflectors.
Replaces a dim or failed LT30LP module
Swap this unit when the original lamp reaches the end of its 2,000-hour normal-life rating or the 5,000-hour economy rating and image brightness drops below usable levels. The jump is worth it when the projector warns of lamp end-of-life or when colour fidelity and contrast have visibly degraded.
Verify the LT30LP part number on your projector
Confirm the existing module carries the LT30LP designation before ordering, because NEC uses different lamp codes across its range. Also check that the projector’s lamp-hour counter can be reset after installation so the new 2,000-to-5,000-hour cycle is tracked correctly.
Highlights
- Ready to install with pre-assembled bulb and housing
- 220W NSH lamp delivers reliable brightness
- Up to 5,000 hours lamp life in economy mode
- 2,000 hours standard life for everyday use
- Manufactured to ISO9001 quality standards
Specifications
| Brand | NEC |
|---|---|
| Type | Projector Lamp |
| Wattage | 220W |
| Lamp Life | 2,000 (Normal) - 5,000 (Economy) Hrs. |
Questions about this item
Does the LT30LP housing match the original projector mount?
The module is a fully assembled bulb and housing built to the original specifications, so it fits the projector's lamp compartment without modification.
What is the correct way to seat the lamp module, and what step is often missed?
Slide the assembled unit straight into the compartment until the connector engages, then secure the retaining screw; many users forget to tighten that screw.
When should I plan to replace the NSH 220W bulb based on the rated hours?
Expect roughly 2000 hours in normal mode or up to 5000 hours in economy mode before the lamp reaches end of life.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
MADE IN USA TONER toner cartridge for KIP 7170 103 2 x 400 gm black
- Black
- Compatible



