We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
National Instruments GPIB cable 2 m matte black connectors

National Instruments

National Instruments GPIB Cable 763061-02 Rev C Type X2 2 m

SKU CH-46RD-67YAQ

GPIB cable connects instruments to controllers with a 2 m / 6.56 ft length

  • Length6.56 ft.
  • 2 m length gives flexible bench placement
  • Rev C update improves signal integrity
  • Type X2 connector ensures secure mating
  • 56 ft reach suits standard rack spacing
  • New condition guarantees factory performance

What it is

The National Instruments 763061-02 Rev C Type X2 is a new GPIB interface cable built for laboratory and industrial test equipment. It connects instruments such as oscilloscopes, power supplies and data acquisition modules to a controller. The 6.56 ft length suits typical bench-to-rack distances.

Deciding specification

The only dimensional figure supplied is the 6.56 ft cable length. Verify that this reach matches the spacing between your GPIB controller port and the furthest instrument in the chain before ordering.

Installation notes

The cable uses standard 24-pin GPIB connectors that mate by hand; no tools are required. Ensure the connector screws are finger-tight to avoid intermittent contact caused by vibration. Do not exceed the minimum bend radius during routing, and keep the cable clear of high-temperature surfaces to prevent jacket damage.

Highlights

  • 2 m length gives flexible bench placement
  • Rev C update improves signal integrity
  • Type X2 connector ensures secure mating
  • 56 ft reach suits standard rack spacing
  • New condition guarantees factory performance

Specifications

Length6.56 ft.

Questions about this item

What does the 2 m length mean for placing instruments on a bench?

The 2 m (6.56 ft) cable lets you connect a controller and an instrument up to two metres apart without strain, leaving slack for routing around other equipment.

Which interface does the 763061-02 Rev C Type X2 use and what does that limit?

It uses a GPIB interface, so the link is limited to the GPIB bus specification for data rate and device count.

What physical space and connectors are needed to fit the 763061-02 Rev C Type X2?

Each end has a standard GPIB connector with metric thumbscrews; allow room for the connector body and screw clearance at both the controller and instrument ports.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

More in Network Ethernet Cables

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.