We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black rectangular car amplifier with silver heatsink fins and Nakamichi branding

NAKAMICHI

NAKAMICHI NROD3000.1 3000W car amplifier

SKU CH-W87S-VBBVX

Class D mono amplifier delivering 3000 W at 1 ohm with variable crossover and bass boost

  • TypeAmplifiers
  • Delivers 3000W at 1 ohm for powerful bass
  • Class D design provides 1600W at 2 ohms
  • Frequency response from 10Hz to 20kHz covers full range
  • Variable bass boost 0dB to 10dB enhances low end
  • Compact 235x190x54mm chassis fits tight installations

NROD3000.1 3000W Mono Amplifier

The NAKAMICHI NROD3000.1 is a Class D mono car amplifier rated for 3000W at 1 ohm with 10% THD. It delivers 1600W at 2 ohms and 1000W at 4 ohms, both at 1% THD. A 200A fuse protects the single channel. The unit weighs approximately 2.6kg and measures 235x190x54mm.

Bass Systems Needing High Power at Low Impedance

This amplifier suits installations driving subwoofers wired to a 1 ohm load where maximum output is the priority. Builders who require multi-channel amplification for component speakers or a full-range system should look elsewhere. The mono topology and fixed crossover architecture do not support stereo imaging or mid-range duties.

Handles 1 Ohm Loads With 3000W Headroom

At 1 ohm the amp provides 3000W for demanding subwoofer setups, dropping to 1600W at 2 ohms and 1000W at 4 ohms. Frequency response spans 10Hz to 20kHz with adjustable low-pass from 80Hz to 20kHz and high-pass from 10Hz to 80Hz. Bass boost adds up to 10dB for extra low-end impact.

Highlights

  • Delivers 3000W at 1 ohm for powerful bass
  • Class D design provides 1600W at 2 ohms
  • Frequency response from 10Hz to 20kHz covers full range
  • Variable bass boost 0dB to 10dB enhances low end
  • Compact 235x190x54mm chassis fits tight installations

Specifications

TypeAmplifiers

Questions about this item

What power and ground wiring gauge do I need for the 200A fuse on this NROD3000.1?

The amplifier uses a single 200A fuse, so 0 AWG power and ground cables with a 200A inline fuse near the battery are required.

Can I keep my factory head unit and connect it to the 200mV-5V inputs?

Yes, the input sensitivity range of 200mV to 5V accepts both low-level RCA and high-level speaker outputs from most factory radios.

How do I verify the 10Hz-20kHz frequency response is active after installation?

Play a 10Hz test tone and confirm output, then sweep to 20kHz; the low-pass and high-pass crossovers should engage at their set points between 80Hz and 20kHz.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.