We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper 90-degree elbow fitting with cup ends, wrot copper finish

Mueller Industries, Inc.

Mueller Industries, Inc. STREAMLINE W 07401 1-1/2" Copper DWV 90° Elbow Fitting

SKU CH-C2SY-ZH6G6

Connects 1-1/2 inch copper tubes at a 90 degree angle for DWV, potable water and air systems

  • 90° elbow directs flow efficiently in DWV systems
  • Wrot copper construction resists corrosion for long service life
  • Suitable for air and potable water applications
  • Meets ASME B16.23, ASME B16.29 and NSF/ANSI 61 Annex G standards
  • Withstands operating temperatures up to 250°F

1-1/2" Copper DWV Elbow

The Streamline W 07401 fitting joins two 1-1/2 inch copper tubes at a 90 degree angle. It is made from wrot copper and rated for a maximum operating temperature of 250 degrees F. The fitting meets ASME B16.23, ASME B16.29 and NSF/ANSI 61 Annex G standards for drain, waste, vent and potable water systems.

Installers needing a standard copper sweep

This elbow suits plumbers running DWV lines or potable water supply with cup-to-cup solder joints. It is not pre-cleaned, so the installer must prepare the surfaces before assembly. Builders requiring push-fit, compression or threaded connections should look at a different fitting type.

Verify tube size and joint method

Confirm the existing copper tube has a 1-1/2 inch nominal size and 1-5/8 inch outer diameter to match the cup ends. Ensure the system design calls for a 90 degree directional change and that soldering equipment is available for the cup connections.

Highlights

  • 90° elbow directs flow efficiently in DWV systems
  • Wrot copper construction resists corrosion for long service life
  • Suitable for air and potable water applications
  • Meets ASME B16.23, ASME B16.29 and NSF/ANSI 61 Annex G standards
  • Withstands operating temperatures up to 250°F

Specifications

BrandMUELLER INDUSTRIES

Questions about this item

What size copper tube is required to connect to the 1-1/2" cup ends on this fitting?

The fitting accepts 1-1/2 inch copper tube size, which corresponds to a 1-5/8 inch outer diameter on both ends.

Will this wrot copper elbow handle the temperature of my existing hot water lines?

It is rated for a maximum operating temperature of 250 degrees F, suitable for standard residential hot water systems.

How can I verify the elbow meets code requirements after installation?

The fitting conforms to ASME B16.23, ASME B16.29 and NSF/ANSI 61 Annex G standards, which are marked on the body.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.