We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Yellow full-brim hard hat made of polyethylene with ratchet suspension

MSA

MSA 475366 Full Brim Hard Hat Yellow Polyethylene personal protective equipment

SKU CH-VV50-7EM5D MPN 475366

Full-brim polyethylene hard hat with ratchet suspension meets ANSI Z89.1 2014 and CSA Z94.1 2015 Class E standards

  • MaterialPolyethylene
  • ANSI Type 1 Class E rated protection
  • Full brim shields face and neck from sun and rain
  • Ratchet 4-point suspension adjusts for secure fit
  • Polyethylene shell resists impact and electrical hazards
  • Side accessory slots accept hearing and face protection

MSA V-Gard Full Brim Hard Hat

The MSA 475366 is a Type 1 Class E hard hat built for workers who need overhead impact protection and electrical insulation up to twenty thousand volts. Its polyethylene shell uses a full brim to shed rain and debris away from the face and neck. The four-point ratchet suspension adjusts quickly to fit most head sizes without tools. This hat meets ANSI Z89.1 2014 and CSA Z94.1 2015 standards for industrial head protection.

Suited for general construction and utility crews

The full brim and Class E rating make this helmet a practical choice for outdoor job sites where sun glare rain and accidental contact with live conductors are daily concerns. Side accessory slots accept standard face shields hearing protection or lamp brackets. Workers who require a vented shell for heat dissipation or a high-visibility colour scheme for low-light traffic zones should look at alternative models because this unit has no vents and is standard yellow only.

ANSI Type 1 Class E certification

The single specification that determines suitability is the ANSI Type 1 Class E rating which confirms protection against vertical impact and penetration plus electrical insulation up to twenty thousand volts. If your site risk assessment calls for lateral impact protection Type 2 or a lower electrical class this hat does not meet those requirements.

Highlights

  • ANSI Type 1 Class E rated protection
  • Full brim shields face and neck from sun and rain
  • Ratchet 4-point suspension adjusts for secure fit
  • Polyethylene shell resists impact and electrical hazards
  • Side accessory slots accept hearing and face protection

Specifications

BrandMSA
Model475366
MaterialPolyethylene

Questions about this item

Does the polyethylene shell of the MSA 475366 trap heat when worn all day?

The polyethylene shell has no venting, so heat can build up during extended wear; the ratchet suspension creates a small air gap that helps airflow across the head.

What must I already have to use the side accessory slots on this hard hat?

The side slots accept standard MSA V-Gard accessories such as hearing protectors, face shields or visors that clip into the slot pattern.

Will the ratchet suspension on this model fit over a liner I already use with older V-Gard hats?

Yes, the 4-point ratchet suspension is the current V-Gard standard and is designed to work with the same winter liners and sweatbands used on earlier V-Gard models.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.