Morse
Morse MHSG36 2.25" Carbide Grit Hole Saw
A 57 mm carbide grit hole saw cuts hard or abrasive materials such as cinder block, cast iron and fiberglass, with a gulleted edge for chip clearance and a side slot for easier slug removal
- Cuts hard abrasive materials with carbide grit edge
- 57 mm diameter suits 2.25 inch installations
- Gulleted edge clears chips during cutting
- Side slot eases slug removal from thick stock
- Requires separate Morse arbor MA35PSNCT or MA45PSNCT
2.25" Carbide Grit Hole Saw
The Morse MHSG36 is a 2.25 inch diameter hole saw with a carbide grit edge built for hard or abrasive materials. It cuts cinder block, cast iron, unglazed ceramics, fiberglass and composites. A separate Morse arbor such as the MA35PSNCT or MA45PSNCT is required for operation.
Gulleted edge and side slot under load
The gulleted cutting edge clears chips continuously during the cut, preventing clogging in dense materials. The unique side slot gives extra leverage for removing the slug from various material thicknesses without binding. These features keep the saw cutting steadily through the full depth of the workpiece.
Arbor compatibility and material limits
The saw fits only Morse MA35PSNCT or MA45PSNCT arbors, so the shank size is fixed by that choice. Carbide grit excels in abrasive media but is not suited for clean cutting in wood or thin sheet metal where a toothed blade would be faster. One saw is supplied per box.
Highlights
- Cuts hard abrasive materials with carbide grit edge
- 57 mm diameter suits 2.25 inch installations
- Gulleted edge clears chips during cutting
- Side slot eases slug removal from thick stock
- Requires separate Morse arbor MA35PSNCT or MA45PSNCT
Specifications
| Brand | MORSE |
|---|
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
