We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Monoprice Inc.

Monoprice 104058 6.00 ft 18 AWG 75 Ohm 2200 MHz 3.0 GHz Quad Shield CL2 Coaxial RF Cable White

SKU CH-W1M1-MQ21H

RG6 quad-shield coaxial cable with 18 AWG copper-clad steel conductor, 75 Ohm impedance and 3.0 GHz sweep-tested bandwidth for antenna, cable TV and satellite installs

  • TypeOthers
  • ColorWhite
  • Length6.00 ft.
  • Connector Number2
  • Quad-shield construction blocks interference for clean signals
  • 18 AWG copper-clad steel core delivers reliable conductivity
  • Sweep-tested to 3.0 GHz bandwidth for high-frequency use
  • CL2-rated jacket permits in-wall installation runs
  • 00 ft length suits typical device-to-wall connections

Monoprice 104058 6 ft Quad Shield Coaxial Cable

This 6.00 ft white coaxial cable uses an 18 AWG copper-clad steel centre conductor with quad shielding and a 75 Ohm impedance. It is built for antenna, cable television and satellite installations where reliable signal transmission matters. The F-type connectors on both ends are sweep tested to 3.0 GHz for consistent performance across applicable frequencies. It carries a CL2 rating for in-wall use.

Sustained signal integrity

Sweep testing verifies that the cable maintains its specified performance up to 3.0 GHz across the full length rather than only at a single spot. The foam polyethylene dielectric and quad shield construction work together to minimise attenuation and external interference during continuous use. This design supports the 2200 MHz rating for satellite and broadband signals over long runs. The 75 Ohm impedance stays stable under sustained load.

Simple F-type connection with CL2 in-wall rating

The pre-attached F-type connectors screw onto standard equipment ports without special tools. The CL2 rating means the jacket meets fire-safety requirements for routing through residential walls. Installers should avoid sharp bends that could deform the dielectric and degrade the 75 Ohm match. Over-tightening the connectors can damage the centre pin or shield contact. The white jacket blends with typical baseboard and ceiling trim.

Highlights

  • Quad-shield construction blocks interference for clean signals
  • 18 AWG copper-clad steel core delivers reliable conductivity
  • Sweep-tested to 3.0 GHz bandwidth for high-frequency use
  • CL2-rated jacket permits in-wall installation runs
  • 00 ft length suits typical device-to-wall connections

Specifications

BrandMonoprice
Model104058
TypeOthers
ColorWhite
Length6.00 ft.
Connector Number2

Questions about this item

Does the 75 Ohm 2200 MHz quad-shield design stay cool during continuous satellite use?

Coaxial cables carry only RF signals, so they generate no measurable heat and require no active cooling.

What equipment must already have F-type ports for this 6.00 ft RG6 cable to connect?

Any device with a standard F-type jack — cable boxes, satellite receivers, antennas, or wall outlets — will accept the connectors on both ends.

Will the 18 AWG copper-clad steel centre conductor work with older analogue cable outlets?

Yes, the RG6 quad-shield construction is fully backward-compatible with legacy 75 Ohm coaxial installations.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.