MOGAOPI 4-in-1 Solder Removal Tool Kit
A four-piece solder-removal kit with a one-handed vacuum pump, spare nozzle, 1.5 m copper braid and 15 cm silicone tube
- Watts0
- Commercial/ResidentialResidential
- One-handed operation with double-ring vacuum trigger
- 15 cm silicone tube shields fingers from heat
- 5 m copper braid wick absorbs molten solder
- 5 mm wick width reaches tight joints
- 206 mm pump body fits left or right hand
4-in-1 Solder Removal Kit
The MOGAOPI kit bundles a desoldering vacuum pump, a spare nozzle, a copper braid solder wick and a 15 cm high-temperature silicone protective tube. It is aimed at hobbyists and technicians who need a compact set for through-hole and surface-mount rework on residential electronics projects.
2.5 mm x 1.5 m copper braid and vacuum pump capacity
The 2.5 mm wide, 1.5 m long rosin-core copper braid absorbs small molten solder deposits cleanly in tight pads. The double-ring vacuum pump pulls larger volumes of solder in a single stroke, but the braid length limits extended production use without replacement.
206 mm ABS pump with nylon nozzle and spare
The 206 mm long ABS body fits either hand and the nylon nozzle withstands soldering iron heat for repeated cycles. The covered sponge grip resists sweat and heat, while the included spare nozzle and silicone tube extend service life without extra purchases.
Highlights
- One-handed operation with double-ring vacuum trigger
- 15 cm silicone tube shields fingers from heat
- 5 m copper braid wick absorbs molten solder
- 5 mm wick width reaches tight joints
- 206 mm pump body fits left or right hand
Specifications
| Watts | 0 |
|---|---|
| Commercial/Residential | Residential |
Questions about this item
Will the 206 mm desoldering pump and 2.5 mm wide solder wick work together on a vintage through-hole board?
The pump clears large solder volumes with its high-pressure vacuum, while the 1.5 m copper braid handles small joints and tight spaces on the same board.
How can I confirm the pump is locking and releasing correctly after assembly?
Press the plunger until you hear a click, heat a joint until the solder melts, position the nozzle, then press the trigger — the molten solder should be drawn into the chamber.
Does the kit include the 15 cm silicone protective tube and a spare nozzle, or must I buy them separately?
Both the high-temperature silicone tube and one spare nylon nozzle are supplied in the box; no extra purchase is needed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
