Mitsubishi
Mitsubishi XD3500U 330W projector lamp
A 330 W replacement lamp module with bulb and housing ready for installation, rated for 2,000 hours normal or 4,000 hours economy use
- TypeProjector Lamp
- Wattage330W
- Lamp Life2,000 (Normal) - 4,000 (Economy) Hrs.
- Genuine OEM NSHA bulb ensures reliable ignition and colour accuracy
- 330 W output matches original projector specification for consistent brightness
- Lamp life up to 2 000 hours normal or 4 000 hours economy mode
- Pre-assembled housing allows quick tool-free replacement
- Manufactured under ISO 9001 quality checks for beam performance and run-time
Direct replacement for Mitsubishi projectors
The Mitsubishi XD3500U lamp module ships new with a 330 W NSHA bulb pre-mounted in its housing. It matches the VLT-XD3200LP part number and is ready for immediate installation in compatible Mitsubishi projectors.
Restores brightness after 2000 to 4000 hours
Replace the original lamp when its output drops below usable levels after roughly 2000 hours in normal mode or 4000 hours in economy mode. The swap is worthwhile once image quality degrades or the projector signals end of life.
Fits the existing lamp compartment
The assembled unit slides into the projector’s lamp bay without extra tools or adapters. It draws the same 330 W as the factory module, leaving power and cooling requirements unchanged.
Highlights
- Genuine OEM NSHA bulb ensures reliable ignition and colour accuracy
- 330 W output matches original projector specification for consistent brightness
- Lamp life up to 2 000 hours normal or 4 000 hours economy mode
- Pre-assembled housing allows quick tool-free replacement
- Manufactured under ISO 9001 quality checks for beam performance and run-time
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 330W |
| Lamp Life | 2,000 (Normal) - 4,000 (Economy) Hrs. |
Questions about this item
Does the VLT-XD3200LP module come fully assembled with the 330 W NSHA bulb already seated in the housing?
Yes, the module ships as a complete unit with the 330 W NSHA bulb pre-installed in the housing, so no separate bulb handling is required.
After removing the old module, what is the step installers most often skip when fitting the replacement?
The most commonly missed step is resetting the projector’s lamp-hour counter through the on-screen menu immediately after the new module is seated.
At what point should I plan to replace the lamp again if I run the projector in Economy mode?
In Economy mode the lamp is rated for approximately 4 000 hours before a replacement is needed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



