Mitsubishi XD350 250W Projector Lamp 1500 Hrs

Ready-to-install lamp module

The Mitsubishi XD350 lamp ships as a fully assembled 250W P-VIP bulb inside its housing, so it fits directly into compatible Mitsubishi projectors without extra assembly. Installation typically involves opening the lamp door, releasing the securing screw, sliding the old module out and inserting the new one until it seats firmly. The most common issue is forgetting to reset the projector’s lamp-hour counter after replacement, which can leave the replacement warning active even though the new lamp is working correctly.

1,500-hour rated lifespan

At the rated 250W power draw the lamp is specified for 1,500 hours of operation before brightness drops to roughly half its initial output. Actual runtime varies with the projector’s eco-mode settings, ambient temperature and how often the unit is power-cycled. Running the projector in high-brightness mode continuously will reach the rated limit sooner, while frequent on-off cycles add thermal stress that can shorten practical life below the nominal figure.

Steady output under continuous use

During extended sessions the lamp maintains stable colour balance and ignition reliability because each unit is tested for beam performance, voltage regulation and run-time to ISO 9001 standards before shipping. The housing and bulb are matched to dissipate heat evenly, preventing hot-spots that cause premature dimming or flicker during long presentations. Allowing the projector’s cooling fan to complete its shutdown cycle after each use protects the lamp from thermal shock and preserves consistent output over the full service interval.