Mitsubishi
Mitsubishi SD200U projector lamp 210W 60.J3416.CG1
A 210 W replacement lamp module with bulb and housing, rated for 2,000 normal or 3,000 economy hours
- TypeProjector Lamp
- Wattage210W
- Lamp Life2,000 (Normal) - 3,000 (Economy) Hrs.
- Ready to install with pre-assembled housing
- 210 W NSH bulb powers the projector
- 2 000 hours normal mode lamp life
- 3 000 hours economy mode extends use
- Built to ISO 9001 quality standards
Genuine Compatible Lamp for SD200U
This replacement module fits the Mitsubishi SD200U projector and arrives as a fully assembled bulb and housing. It is built for technicians or owners who need a direct swap without extra tools or alignment steps. The unit ships ready to install in the compatible Mitsubishi model.
210 Watt NSH Bulb
The lamp uses a 210W NSH bulb, which is the single specification that determines compatibility with the projector's power supply and optical engine. Using a different wattage would cause ignition errors or premature failure, so this exact rating must match the original part.
Rated Life Under Continuous Use
In normal mode the lamp is rated for 2,000 hours and in economy mode for 3,000 hours, reflecting sustained output rather than a brief peak. Extended sessions at full brightness will track toward the lower figure, while reduced-power operation stretches the interval toward the higher one.
Highlights
- Ready to install with pre-assembled housing
- 210 W NSH bulb powers the projector
- 2 000 hours normal mode lamp life
- 3 000 hours economy mode extends use
- Built to ISO 9001 quality standards
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 210W |
| Lamp Life | 2,000 (Normal) - 3,000 (Economy) Hrs. |
Questions about this item
How bright will the 210 W lamp be in my SD200U projector?
The 210 W NSH bulb restores the projector’s original light output so images look as bright as they did when the unit was new.
Does the lamp module use a standard connector that fits the SD200U socket?
Yes, the housing is built to the Mitsubishi 60.J3416.CG1 specification and plugs directly into the projector’s lamp socket without adapters.
What clearance does the assembled lamp and housing need inside the projector?
The module is a complete drop-in unit sized for the SD200U lamp compartment; no extra space beyond the standard bay is required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



