We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
A rectangular projector lamp module with a silver metal housing and a clear glass bulb inside

Mitsubishi

Mitsubishi SD110 Projector Lamp 200W

SKU CH-FGA8-31XWA

Replacement 200W UHP projector lamp module with 2,000 to 4,000 hour life for easy installation

  • TypeProjector Lamp
  • Wattage200W
  • Lamp Life2,000 (Normal) - 4,000 (Economy) Hrs.
  • Ready-to-install module saves setup time
  • 200 W UHP bulb powers bright projection
  • 2 000 hrs normal or 4 000 hrs economy mode
  • Built to ISO 9001 quality standards
  • Genuine OEM or compatible versions available

Replacement lamp for Mitsubishi projectors

This 200W lamp module fits Mitsubishi SD110 projectors and arrives as a complete bulb-and-housing assembly for immediate installation. The UHP light source delivers up to 2,000 hours in normal mode or 4,000 hours in economy mode. Each unit is built to ISO9001 quality standards.

Suits owners needing a direct-fit module

Buyers who require a bare bulb without housing or a different wattage rating should look elsewhere. The lamp is offered in several OEM and compatible versions, all tested for beam performance, ignition, voltage and run-time before shipping.

200W UHP lamp with dual-mode life rating

Normal operation provides 2,000 hours of use while economy mode extends that to 4,000 hours, letting you balance brightness against replacement frequency. The fully assembled housing eliminates alignment steps during fitting.

Highlights

  • Ready-to-install module saves setup time
  • 200 W UHP bulb powers bright projection
  • 2 000 hrs normal or 4 000 hrs economy mode
  • Built to ISO 9001 quality standards
  • Genuine OEM or compatible versions available

Specifications

TypeProjector Lamp
Wattage200W
Lamp Life2,000 (Normal) - 4,000 (Economy) Hrs.

Questions about this item

What lamp interface does the Mitsubishi SD110 projector require and what wattage does it limit?

The Mitsubishi SD110 projector uses a 200W UHP lamp module; the housing and connector are built to that exact wattage so the projector's power supply and ballast are matched to 200W.

What physical components come with the replacement lamp and how do they fit the Mitsubishi SD110?

The replacement module includes a new 200W UHP bulb pre-assembled in its housing, matching the original VLT-XD110LP form factor so it seats directly in the SD110 lamp compartment without extra brackets.

How is the lamp module installed in the Mitsubishi SD110 and which step is often missed?

Power off and cool the projector, remove the lamp cover, release the securing screws, slide the old module out, insert the new VLT-XD110LP module until it clicks, re-tighten the screws, replace the cover, then reset the lamp timer in the menu — the timer reset is the step most often forgotten.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.