Mitsubishi LVP-SL1 150W 2500 Hrs projector lamp

Direct replacement module

The Mitsubishi LVP-SL1 module supplies a pre-assembled UHP bulb inside its housing so the projector can be relamped without handling a bare lamp. It matches the original VLT-XL1LP fitment and is intended for owners of compatible Mitsubishi projectors who need a ready-to-install light source. The unit arrives new and passes ISO 9001 quality checks for beam performance, ignition, voltage, appearance, connections and run-time before it ships.

Housing and connector integrity

A fully assembled housing protects the 150W bulb from dust and misalignment during swap-out, while the factory connectors slot into the projector without adapters. Each lamp is tested for reliable ignition and stable voltage so the image appears quickly and stays consistent through daily use. The sealed housing also means no separate bulb seating or focus adjustment is required after installation.

Fixed 2 500 hour service interval

The UHP lamp is rated for 2 500 hours of operation, after which brightness and colour uniformity will decline and a replacement becomes necessary. Projectors that run continuously or in high-brightness modes will reach this limit sooner than those used intermittently. Buyers who need longer intervals between lamp changes should consider projectors that support higher-rated light engines, as this module’s lifespan is defined by the 150W UHP specification.