Mitsubishi
Mitsubishi LVP-SD200 Projector Lamp 210W
Genuine 210 W replacement lamp module with NSH bulb and housing, rated 2,000 to 3,000 hours
- TypeProjector Lamp
- Wattage210W
- Lamp Life2,000 (Normal) - 3,000 (Economy) Hrs.
- Genuine compatible module installs instantly
- NSH 210W bulb powers bright projection
- Lamp life reaches 2,000 normal hours
- Economy mode extends use to 3,000 hours
- ISO 9001 quality checks ensure reliable operation
Genuine Compatible 210W Lamp Module
This Mitsubishi LVP-SD200 lamp is a new replacement module that pairs a 210W NSH bulb with a complete housing. It arrives fully assembled and ready for direct installation in supported Mitsubishi projectors. The unit is manufactured to ISO 9001 quality standards and undergoes checks for beam performance, ignition, voltage, appearance, connections and run-time.
Ideal for Direct Replacement.
The module suits users who need a ready-to-fit lamp for a Mitsubishi projector that accepts the LVP-SD200 designation. Buyers who only want a bare bulb without the housing should look at a different product, as this item is supplied as a complete unit. It is also not intended for projectors that require a different lamp code or wattage.
210W NSH Bulb Determines Brightness and Life
The lamp uses a 210W NSH bulb rated for 2,000 hours in normal mode and up to 3,000 hours in economy mode. Matching this wattage and lamp type to the projector's specifications is the single factor that decides whether the module is the correct part.
Highlights
- Genuine compatible module installs instantly
- NSH 210W bulb powers bright projection
- Lamp life reaches 2,000 normal hours
- Economy mode extends use to 3,000 hours
- ISO 9001 quality checks ensure reliable operation
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 210W |
| Lamp Life | 2,000 (Normal) - 3,000 (Economy) Hrs. |
Questions about this item
Does the Mitsubishi LVP-SD200 lamp need a specific projector model to operate?
This 210 W replacement module is built for Mitsubishi projectors that accept the LVP-SD200 lamp code; verify your projector’s required lamp type before ordering.
Can I keep using my existing ceiling mount and cables when I swap in this 210 W lamp?
Yes, the lamp ships as a complete bulb-and-housing unit that fits the original lamp cavity, so mounts and signal cables remain unchanged.
How do I confirm the new lamp is working correctly after installation?
Power on the projector, check that the lamp indicator shows normal status, and reset the lamp-hour counter to begin tracking the 2,000-hour normal or 3,000-hour economy rating.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



