Mitsubishi
Mitsubishi HC3900 DLP Replacement Lamp Housing with OEM Bulb
A ready-to-install DLP lamp housing with a genuine OEM bulb for the HC3900 projector
- TypeProjector Lamps
- Genuine OEM bulb ensures original brightness and colour accuracy
- 180‑day warranty protects against defective units
- Compatible housing fits Mitsubishi HC3900 projector without modification
- Engineered to meet exact manufacturer specifications for reliable performance
- Direct OEM sourcing guarantees superior longevity over generic alternatives
Direct Replacement for HC3900 Projectors
This lamp assembly fits the Mitsubishi HC3900 projector and arrives as a complete housing with an original OEM bulb inside. It is intended for owners who need to restore factory brightness after the original lamp reaches end of life.
Upgrade from Generic Compatible Lamps
The unit replaces third‑party compatible lamps that use non‑OEM bulbs and often deliver lower output or shorter service intervals. The jump is worth it when colour accuracy and consistent light output are critical for home‑theatre viewing.
Practical Limits of the Lamp Interface
Light output and lamp life remain bound to the projector's built‑in power supply and cooling design; the housing cannot exceed the manufacturer's specified drive current. The 180‑day warranty covers defects but does not extend to failures caused by projector malfunction or improper installation.
Highlights
- Genuine OEM bulb ensures original brightness and colour accuracy
- 180‑day warranty protects against defective units
- Compatible housing fits Mitsubishi HC3900 projector without modification
- Engineered to meet exact manufacturer specifications for reliable performance
- Direct OEM sourcing guarantees superior longevity over generic alternatives
Specifications
| Brand | Mitsubishi |
|---|---|
| Type | Projector Lamps |
Questions about this item
Will the HC3900 housing fit the Mitsubishi HC3900 projector without modification?
The housing assembly is built for the Mitsubishi HC3900 projector and matches the original dimensions so it seats directly in the lamp compartment.
What is the installation step that people often miss when fitting the HC3900 lamp?
After inserting the housing, the lamp cover must be fully closed and latched because the projector will not power on if the cover sensor detects it is open.
When should the OEM bulb inside the HC3900 housing be replaced?
Replace the lamp when the projector's lamp-hour counter reaches the manufacturer's recommended limit or when image brightness drops noticeably.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



