Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00951132BTC
In stock
Milwaukee Valve
Milwaukee Valve UPBA475B 2 in Manual 2-Way Ball Valve Brass
A manual two-way brass ball valve with full-port chrome-plated ball and locking lever handle rated for 600 psi water service
- TypeOther
- Full-port design maintains unrestricted water flow
- 600 psi pressure rating handles demanding applications
- Locking lever handle prevents accidental operation changes
- Chrome-plated brass ball resists corrosion and wear
- Vacuum service rated to 29.92 in Hg
Manual Two-Way Ball Valve for Water Systems
The Milwaukee Valve UPBA475B is a 2-inch manual ball valve constructed from brass with a chrome-plated brass ball. It features a full-port design and a two-piece straight body rated for water media. A locking lever handle provides secure operation for residential or commercial plumbing installations.
Replaces Worn or Undersized Shut-Off Valves
This valve upgrades older gate valves or smaller-diameter ball valves that restrict flow or fail to seal under pressure. The jump is worth it when a full-port 2-inch pathway is required to maintain system capacity and a 600 psi operating-pressure rating matches the service conditions.
Verify Thread Type and Pressure Compatibility
Confirm that the existing piping uses NPT threads to match the valve connections. Ensure the system operating pressure does not exceed 600 psi and that vacuum service down to 29.92 in Hg is acceptable. The valve is not rated for steam or combustible gas applications.
Highlights
- Full-port design maintains unrestricted water flow
- 600 psi pressure rating handles demanding applications
- Locking lever handle prevents accidental operation changes
- Chrome-plated brass ball resists corrosion and wear
- Vacuum service rated to 29.92 in Hg
Specifications
| Brand | MILWAUKEE VALVE |
|---|---|
| Type | Other |
Questions about this item
What thread size does the 2 in NPT valve require for piping?
The valve uses 2 in NPT threads on both ends, so matching 2 in NPT nipples or adapters are needed for a leak-free connection.
How should the lever handle be oriented during installation to avoid reverse flow indication?
Install the valve so the lever aligns with the pipe when open and crosses it when closed; the locking hole lines up only in the fully closed position.
When should the chrome-plated brass ball and PTFE seats be inspected or replaced?
Inspect the ball and seats annually or after 600 psi pressure cycles; replace if leakage appears at the stem or across the closed port.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
