Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00931157BTC
In stock
Milwaukee Valve
Milwaukee Valve UP668 1/2" Gate Valve Solder Low Lead Brass
A 1/2-inch solder gate valve in low-lead brass rated for 200 psi water service with a 17.6 Cv flow coefficient
- TypeOther
- Low-lead brass body meets safe-water standards
- 200 psi pressure rating handles demanding plumbing systems
- 6 Cv coefficient delivers strong flow capacity
- Solder sweat connection creates permanent leak-free joints
- Non-rising stem design saves space in tight installations
1/2" Gate Valve for Water Systems
This 1/2 inch gate valve controls water flow in residential and commercial plumbing installations. The low-lead brass construction meets safety requirements for potable water supply lines. It is designed for solder connection on copper piping systems.
Brass Body with Wheel Handle Operation
The valve body, bonnet, stem, wedge, seat and seal are all made from brass for corrosion resistance. A forged brass solid wedge provides a tight shut-off against the brass seats. The non-rising stem with screw-in bonnet keeps the handle height constant during operation. A wheel handle allows precise manual control of the flow.
Verify Sweat Connection and Pressure Rating
Confirm your piping uses 1/2 inch copper tube sized for sweat solder joints before ordering. The maximum operating pressure is 200 psi for water service only; steam service is not applicable. The flow coefficient Cv is 17.6 for system sizing calculations. Ensure local codes permit this valve type for the intended application.
Highlights
- Low-lead brass body meets safe-water standards
- 200 psi pressure rating handles demanding plumbing systems
- 6 Cv coefficient delivers strong flow capacity
- Solder sweat connection creates permanent leak-free joints
- Non-rising stem design saves space in tight installations
Specifications
| Brand | MILWAUKEE VALVE |
|---|---|
| Type | Other |
Questions about this item
What is the maximum operating pressure this 1/2" gate valve can handle?
The valve is rated for a maximum operating pressure of 200 psi for water service.
What pipe size and connection method does this valve require for installation?
It fits 1/2 inch nominal copper tubing and uses a sweat solder connection on the inlet side.
How is the bonnet secured, and what is a common mistake during assembly?
The bonnet uses a screw-in design; the common error is over-tightening it, which can crack the brass body.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
