Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.0094001BTC
In stock
Milwaukee Valve
Milwaukee Valve 115 Gate Valve Class 125 2-1/2 in Solder
A 2-1/2 inch bronze gate valve rated for 200 psi water and 125 psi steam with a 337 Cv flow coefficient
- TypeOther
- Rated for 200 psi water, oil and gas service
- Handles 125 psi steam with bronze seat and seal
- Non-rising bronze stem saves clearance above the valve
- 337 Cv flow coefficient minimises pressure drop
- Solder connection installs without threading tools
Bronze Gate Valve for Gas Oil Water
The Milwaukee Valve 115 is a Class 125 bronze gate valve designed for controlling gas, oil or water flow in plumbing and light industrial systems. It suits installers who need a solder-end connection on a two-and-a-half-inch line. Buyers who require flanged or threaded ends cannot use this model.
Non-Rising Stem 200 psi Operating Pressure
The valve carries a maximum operating pressure of 200 psi and a steam rating of 125 psi. A non-rising bronze stem and solid bronze wedge reduce the clearance needed above the pipe. Bronze seat and seal materials provide consistent shut-off without external lubrication.
Sweat Connection Wheel Handle Ready to Install
A sweat connection on the inlet side allows direct soldering to copper tubing without extra fittings. The screw-in bonnet and wheel handle are factory assembled so the valve can be installed immediately. No separate packing or actuator parts are required.
Highlights
- Rated for 200 psi water, oil and gas service
- Handles 125 psi steam with bronze seat and seal
- Non-rising bronze stem saves clearance above the valve
- 337 Cv flow coefficient minimises pressure drop
- Solder connection installs without threading tools
Specifications
| Brand | MILWAUKEE VALVE |
|---|---|
| Type | Other |
Questions about this item
How do I solder the 2-1/2 in sweat connection on the 115 gate valve without damaging the bronze seats?
Disassemble the bonnet and remove the wedge before applying heat. Use a wet rag on the body to keep the bronze seats and seals below soldering temperature while you sweat the joint.
What maintenance will the non-rising stem and bronze wedge need over time?
Operate the wheel handle fully open and closed monthly to prevent the bronze wedge from seizing in the bronze body. Repack the screw-in bonnet if stem leakage appears.
At what pressure limit does the Class 125 bronze body restrict sustained steam service?
The valve is rated for 125 psi maximum steam pressure. Sustained steam above this limit will exceed the Class 125 body rating first.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
