Miller Enterprises
Miller Enterprises 796F74 Lava X-Long Nozzle No 3 (3/16 In) PK10
Pack of ten extra-long lava nozzles, size 3 (3/16 in), for WP-9 and WP-20 series torches up to .5 in electrode
- TypeWelding Parts & Supplies
- Compatible with WP-9, WP-20 and WP-25 series torches
- Lava material resists high-temperature spatter during welding
- X-Long Nozzle No. 3 extends reach for tight joints
- Pack of 10 nozzles reduces downtime between changes
- Fits electrodes up to .5 inch diameter
Miller Lava X-Long Nozzle No. 3
This pack contains ten lava nozzles sized No. 3 with a 3/16 inch bore. They are built for TIG welding torches where a longer tip reach improves access to tight joints. The ceramic lava material handles high heat during extended welding cycles.
Replaces worn standard-length nozzles
Swap these in when the original nozzle cracks, melts or no longer shields gas effectively. The extended length is worth it only when the joint geometry demands extra reach; on open, flat work a standard nozzle is faster to manipulate and less prone to accidental contact.
Limited to compatible torch models
These nozzles fit only the listed Miller and Weldcraft torch series including 9, 20, 22, 25 and related HW, WP, PTA and PTW models. They will not thread onto torches from other brands or unlisted series. Maximum electrode diameter is .5 inch, so larger rods require a different nozzle size.
Highlights
- Compatible with WP-9, WP-20 and WP-25 series torches
- Lava material resists high-temperature spatter during welding
- X-Long Nozzle No. 3 extends reach for tight joints
- Pack of 10 nozzles reduces downtime between changes
- Fits electrodes up to .5 inch diameter
Specifications
| Brand | MILLER ELECTRIC |
|---|---|
| Type | Welding Parts & Supplies |
Questions about this item
Will the 3/16 in nozzle fit my WP-9 series torch?
Yes, the nozzle is compatible with WP-9, WP-9F, WP-9V, WP-9FV and HW-9 models, plus the PTA-9 and PTW-20 series torches.
How do I install the lava nozzle without cracking it?
Thread the nozzle onto the torch head by hand until snug; do not use pliers or over-tighten, as the lava material can fracture under excessive force.
When should I replace these No. 3 lava nozzles?
Replace a nozzle when the 3/16 in bore becomes eroded, the lava shows cracks, or spatter buildup restricts gas flow, typically after heavy use at up to .5 in electrode diameter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
