MIDWEST FASTENER CORP
MIDWEST FASTENER CORP 74854 5/32" x 1-1/2" 18-8 Stainless Steel Cotter Pins 12PK hardware
Pack of twelve 18-8 stainless steel cotter pins for securing metal assemblies
- TypePins
- Corrosion-resistant 18-8 stainless steel withstands moisture and chemicals
- Split-pin design locks assemblies securely with bent tines
- Twelve pins per pack supply enough for multiple repairs
- 5/32" diameter fits standard cotter-pin holes in machinery
- 1-1/2" length spans typical castle-nut and drilled-bolt combinations
12-Pack Stainless Steel Cotter Pins
This pack contains twelve 18-8 stainless steel cotter pins measuring 5/32 inch by 1-1/2 inches. They are designed to secure metal assemblies by inserting the split pin and bending the two tines. The corrosion-resistant material suits automotive, marine and general mechanical fastening tasks.
Simple Hand Installation
Install by pushing the pin through the aligned hole until the head seats, then bend both tines outward with pliers or a screwdriver. The split design locks the pin in place under vibration. A common issue is bending a tine too sharply, which can weaken the metal and cause it to snap during service.
Limited to Drilled Hole Alignment
These pins require a pre-drilled cross hole in the bolt or shaft that matches the 5/32 inch diameter. They cannot clamp parts together or pull a joint tight; they only prevent a nut or clevis from rotating off. Applications needing adjustable tension or blind-side access will need a different fastener type.
Highlights
- Corrosion-resistant 18-8 stainless steel withstands moisture and chemicals
- Split-pin design locks assemblies securely with bent tines
- Twelve pins per pack supply enough for multiple repairs
- 5/32" diameter fits standard cotter-pin holes in machinery
- 1-1/2" length spans typical castle-nut and drilled-bolt combinations
Specifications
| Brand | MIDWEST FASTENER |
|---|---|
| Type | Pins |
Questions about this item
How can I confirm the cotter pins are holding securely after installation?
Bend both tines outward around the fastened parts so the pin cannot back out.
What comes in the package and is anything else required?
Twelve 18-8 stainless steel cotter pins are included; no additional parts are needed for basic fastening.
Which pack size should I choose for a small repair job?
The 12-count pack provides enough pins for several assemblies without excess inventory.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
