MIDWEST FASTENER CORP
MIDWEST FASTENER CORP 50272 Hitch Pin Clips 100PK
One hundred zinc-plated steel R-clips secure clevis pins and shafts on trailers, farm equipment and automotive linkages
- TypePins
- Secures shafts with spring-tempered R-shape wire
- Zinc-plated steel resists corrosion in outdoor use
- 100 clips supply multiple repair jobs
- Fits 3/32" x 2-5/16" clevis pins and axles
- Ready for automotive, farm and trailer hardware
Bulk Hitch Pin Clips
A 100-pack of zinc-plated steel hitch pin clips supplies workshops, farms and fleet yards with a ready stock of reusable fasteners. The R-shaped wire form snaps over the end of a clevis pin or axle to prevent it from sliding out during vibration or load changes. Buyers who need only a few pieces for a one-time repair will find the quantity excessive.
Replaces Lost Or Worn Clips
When original clips bend, corrode or disappear during maintenance, this bulk box restores the secure fit without waiting for single-unit orders. The jump is worth it whenever equipment sees repeated pin removal, such as trailer swaps, implement changes or seasonal axle servicing. Shops that rarely touch hitch hardware gain no advantage from the volume.
100-Piece Capacity For Recurring Jobs
The pack covers dozens of pin-securing cycles across multiple machines, keeping spares on hand for the next round of hook-ups. It runs out when the clip diameter or wire gauge does not match the shaft being secured, or when a non-metallic fastener is required for electrical isolation.
Highlights
- Secures shafts with spring-tempered R-shape wire
- Zinc-plated steel resists corrosion in outdoor use
- 100 clips supply multiple repair jobs
- Fits 3/32" x 2-5/16" clevis pins and axles
- Ready for automotive, farm and trailer hardware
Specifications
| Brand | MIDWEST FASTENER |
|---|---|
| Type | Pins |
Questions about this item
What shaft diameter does the 3/32 inch wire suit?
The 3/32 inch wire diameter is made for shafts with a matching cross-drilled hole, typically around 3/16 to 1/4 inch.
How do I seat the clip so the straight leg locks?
Push the straight leg through the hole until the curved body snaps over the shaft end; the step missed is not fully depressing the curve.
When should the zinc plated clips be replaced?
Replace any clip that shows white corrosion, a widened gap, or a leg that no longer springs back sharply.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
