We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Micro 100 carbide engraving tool, 5.00 mm, AlTiN coated, double 90 degree tip

Micro 100

Micro 100 RNCM-030-2X Engraving Tool Double 90 Degrees Carbide AlTiN Metric 5.00 mm

SKU CH-NTZW-5950P

Double 90-degree carbide engraving tool with AlTiN coating for metric 5.00 mm cutting

  • Double 90° tip creates clean V-grooves
  • Carbide body resists wear in abrasive materials
  • AlTiN coating extends tool life at speed
  • Metric 5.00 mm shank fits standard holders
  • 30 mm length of cut handles deep engraving

Micro 100 Double Engraving Tool

The Micro 100 RNCM-030-2X is a double-ended carbide engraving tool with a 90-degree included angle and AlTiN coating. It is supplied as a new accessory for power and pneumatic equipment. The 5.00 mm length of cut suits detailed marking work in metric workflows.

Best for CNC engraving and marking

Machinists who need a coated carbide tool for fine engraving on ferrous and non-ferrous materials will find this double-ended design practical. Shops requiring larger cutting diameters, different included angles, or uncoated substrates should select an alternative tool from the range.

Simple collet or holder installation

The tool installs directly into a compatible collet or tool holder for immediate use. Problems usually arise from excessive run-out, incorrect feed rates for the material, or insufficient rigidity in the setup causing premature wear or chatter.

Highlights

  • Double 90° tip creates clean V-grooves
  • Carbide body resists wear in abrasive materials
  • AlTiN coating extends tool life at speed
  • Metric 5.00 mm shank fits standard holders
  • 30 mm length of cut handles deep engraving

Specifications

BrandMICRO 100

Questions about this item

What spindle or collet size fits the 5.00 mm shank on this engraving tool?

The tool has a 5.00 mm shank, so you need a collet or chuck that accepts 5.00 mm diameter.

Can I run this 90-degree carbide tool at the same feeds as an older high-speed steel engraver?

Carbide with AlTiN coating tolerates higher surface speeds than HSS, so you can increase feed rates while keeping chip load appropriate.

How do I verify the double 90-degree geometry is cutting correctly after setup?

Inspect the engraved groove: both faces should meet at a clean 90-degree included angle with no chatter marks on the AlTiN surface.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.