Micro 100
Micro 100 RNCM-030-1X Engraving Tool 5.00 mm 90 Degrees Carbide AlTiN
Carbide engraving tool with 5.00 mm cut length, 90-degree angle and AlTiN coating
- 90-degree carbide tip engraves hard materials cleanly
- AlTiN coating extends tool life in abrasive cuts
- 00 mm length of cut suits fine detail work
- Micro 100 precision grinding ensures consistent edge geometry
- Single-flute design clears chips efficiently in tight spaces
Engraving Tool 5.00 mm 90 Degrees
Micro 100 RNCM-030-1X is a single carbide engraving tool with a 5.00 mm length of cut and a 90 degree angle. It is built for precision marking and engraving tasks in professional workshops. The AlTiN coating supports wear resistance during repeated use.
Sustained Engraving Performance
Carbide construction and AlTiN coating maintain cutting geometry under continuous load rather than only in short passes. The tool resists heat buildup and edge degradation during extended engraving cycles. Consistent material removal is achieved without frequent tool changes.
Metric Standard Practical Limits
The 5.00 mm length of cut defines the maximum depth reachable in a single pass within the metric standard. The 90 degree included angle limits the profile to V shaped grooves of that geometry. Users needing different depths or angles must select alternative tooling.
Highlights
- 90-degree carbide tip engraves hard materials cleanly
- AlTiN coating extends tool life in abrasive cuts
- 00 mm length of cut suits fine detail work
- Micro 100 precision grinding ensures consistent edge geometry
- Single-flute design clears chips efficiently in tight spaces
Specifications
| Brand | MICRO 100 |
|---|
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
