Micro 100
Micro 100 RC-375080 Brazed Tool Bit
Single-point carbide tool bit with zinc construction and right-hand orientation
- MaterialHAWA
- Weight0.2
- Carbide tip holds a sharp edge longer
- HAWA material resists wear during heavy cuts
- Right-hand design matches standard lathe setups
- 3/8 in shank fits common tool holders
- Light 0.2 lb weight reduces operator fatigue
Single-Point Carbide Tool Bit
The Micro 100 RC-375080 is a right-hand brazed tool bit made from HAWA carbide with a zinc shank. It is intended for machinists and metalworkers who need a durable single-point cutting tool for lathe operations on ferrous and non-ferrous materials.
Shank Dimensions and Machine Fit
The bit features a 3/8 inch shank width and a 6 inch overall length, allowing it to fit standard tool holders that accept this cross-section. Its brazed construction eliminates the need for separate insert indexing, freeing up tool-post space and reducing setup time for turning, facing or boring tasks.
Sustained Cutting Behaviour
The carbide tip maintains hardness at elevated temperatures generated during prolonged cuts, resisting deformation better than high-speed steel alternatives. The zinc shank provides a stable base that dampens vibration during extended passes, helping to preserve surface finish and dimensional accuracy throughout a production run.
Highlights
- Carbide tip holds a sharp edge longer
- HAWA material resists wear during heavy cuts
- Right-hand design matches standard lathe setups
- 3/8 in shank fits common tool holders
- Light 0.2 lb weight reduces operator fatigue
Specifications
| Brand | Micro 100 |
|---|---|
| Material | HAWA |
| Weight | 0.2 |
Questions about this item
How does the HAWA carbide tip hold up when the RC-375080 runs a long production cycle?
The brazed carbide tip resists wear during extended turning passes, keeping a sharp edge on steel and alloy workpieces.
Does the 0.2 lb shank transmit noticeable vibration or heat to the holder during all-day cutting?
The compact 6 in length and rigid carbide braze keep vibration low and heat concentrated at the tip, not the holder.
What tool holder or lathe setup is needed to clamp the 3/8 in shank on the RC-375080?
Any standard 3/8 in square-shank holder or quick-change block will secure the bit for right-hand turning operations.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
