Meterk 2 Pack PIR Motion Sensor Switch 12-24V 6A 8m White
Two-pack PIR motion sensor switches activate 12–24 V DC loads up to 6 A with adjustable 1–10 minute delay and 8 m detection range
- Adjustable 1-10 minute delay saves energy
- 8 metre detection range covers wide areas
- 12-24V DC input suits solar lighting
- 6A capacity handles LED strips directly
- Two switches included for multiple zones
Two-Pack 12-24V PIR Motion Switches
This two-pack supplies 12-24V DC PIR motion sensor switches rated for 6A loads. Each unit detects movement up to 8 metres with a 60-degree field of view. The adjustable delay holds the output on for one to ten minutes after motion stops. They suit 12V solar LED lighting, occupancy control and security lighting systems.
Sustained Operation in Varied Temperatures
The controller operates continuously from -20°C to +60°C without thermal derating mentioned in the data. Its infrared detection method maintains consistent switching behaviour during extended occupancy periods. The adjustable delay prevents rapid cycling when movement persists in the detection zone. Output voltage matches the input supply across the full operating range.
Compact Housing with Simple Wiring
The white housing mounts easily in typical lighting enclosures or junction boxes. Wiring requires the load wire connected first followed by the power wire to avoid short circuits. Signal output and input lines must be connected correctly for proper operation. The two-pack format covers dual zones or provides a spare unit for critical installations.
Highlights
- Adjustable 1-10 minute delay saves energy
- 8 metre detection range covers wide areas
- 12-24V DC input suits solar lighting
- 6A capacity handles LED strips directly
- Two switches included for multiple zones
Specifications
| Brand | Meterk |
|---|---|
| Model | Hand Rivet Nut Setter Kit |
| Part Number | 5598619 |
Questions about this item
How much power does each Meterk PIR sensor draw when it runs continuously?
Each unit operates on 12-24V DC with a maximum load current of 6A; the controller itself consumes only a small quiescent current while the connected LED load determines total draw.
What wiring and voltage source must I already have to install these switches?
You need a 12-24V DC supply and two-wire load connections for each sensor; the pack includes two controllers but no power supply or mounting hardware.
Will the 60-degree detection cone work with the 12V LED strips I already use in my camper?
Yes — the output voltage matches the 12-24V input, so existing 12V strips connect directly and the 8m range covers typical camper lengths.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
