We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Gray bi-polymer coated knit glove pair size S 10-3/16 in

Memphis

Memphis Glove 10-3/16 in S Gray Bi Polymer personal protective equipment

SKU CH-ZHX5-VAGPQ

ANSI A3 cut-resistant bi-polymer glove with level 5 abrasion protection, 10-3/16 inch length

  • MaterialBi Polymer
  • ANSI/ISEA Cut Level A3 protects against moderate cut hazards
  • ANSI/ISEA Abrasion Level 5 delivers high abrasion resistance
  • Dyneema Diamond knit material provides lightweight strength
  • 3/4 dipped coating enhances grip in dry and wet conditions
  • Meets ANSI 105 and EN388 standards for hand protection

10-3/16 inch Bi Polymer Glove

This Memphis glove is personal protective equipment sized at 10-3/16 inches in small. The gray Bi Polymer construction targets workers who need hand protection during general-purpose tasks. It is sold as a single pair for left and right hands. Buyers needing a different length or a heavier coating should look elsewhere.

ANSI 105 and EN388 rated durability

The glove meets ANSI/ISEA cut level A3 and abrasion level 5 under the ANSI 105 and EN388 standards. A 3/4 dip coating covers the palm and fingers while the Dyneema Diamond knit shell resists wear during sustained contact. Double-dipped construction is not used, so the coating remains a single layer. Users requiring double-dipped protection or a fully coated cuff will not find it here.

California Proposition 65 chemical notice

This product carries a California Proposition 65 warning for substances known to cause cancer and birth defects or other reproductive harm. The restriction applies to the glove materials as supplied. Purchasers who must avoid listed chemicals should verify suitability before use. No additional hazard protection beyond the stated cut and abrasion ratings is claimed.

Highlights

  • ANSI/ISEA Cut Level A3 protects against moderate cut hazards
  • ANSI/ISEA Abrasion Level 5 delivers high abrasion resistance
  • Dyneema Diamond knit material provides lightweight strength
  • 3/4 dipped coating enhances grip in dry and wet conditions
  • Meets ANSI 105 and EN388 standards for hand protection

Specifications

BrandMEMPHIS GLOVE
MaterialBi Polymer

Questions about this item

Does the 3/4 coating trap heat during a full shift?

The 3/4 dipped coating leaves the back of the hand open, letting air circulate while the palm stays protected.

Must I already own a specific liner for the ANSI A3 cut rating to apply?

No, the Dyneema Diamond knit delivers ANSI/ISEA Cut Level A3 on its own without an extra liner.

Will these gloves still meet EN388 abrasion level 5 if I wear them over my existing cotton liners?

Yes, the Bi Polymer shell is rated ANSI/ISEA Abrasion Level 5 and EN388 regardless of a thin liner underneath.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.