Maxxima
Maxxima MWL-16-A 2900 lm Square LED Work Light
Square LED work light delivers 2900 lumens of flood illumination with IP67 protection for 12/24V DC vehicles
- Bright flood illumination with 2900 lumen LED output
- Withstands water and dust ingress at IP67 rating
- Operates on 12 or 24 volt DC vehicle systems
- Square head design measures 4 1/8 inch height by 4 5/8 inch width
- Permanent bracket mount with blunt cut wires for direct wiring
2900 lm square LED work light
The Maxxima MWL-16-A delivers 2900 lumens of flood-beam illumination from a square LED housing. It operates on 12 or 24 volt DC systems and mounts via a permanent bracket. An IP67 rating protects the internals against dust and water ingress. The fixture is built for universal fit across vehicle classes 1 through 8.
Replaces halogen or older LED lamps
Upgrading from sealed-beam halogen units or lower-output LED fixtures yields a wider, more even flood pattern. The jump is worthwhile when night-time work areas need consistent coverage without hotspots. Existing blunt-cut wiring simplifies the swap on most 12/24 V platforms. The lamp meets IESNA LM-79 photometric standards for verified output.
Handles wide-area task lighting
At 2900 lumens the light comfortably illuminates loading bays, engine compartments and roadside scenes. Output drops off beyond the designed flood spread, so long-distance spotting is not its role. The fixed bracket and blunt-cut leads limit repositioning once installed. Buyers needing adjustable aim or longer throw should consider a different form factor.
Highlights
- Bright flood illumination with 2900 lumen LED output
- Withstands water and dust ingress at IP67 rating
- Operates on 12 or 24 volt DC vehicle systems
- Square head design measures 4 1/8 inch height by 4 5/8 inch width
- Permanent bracket mount with blunt cut wires for direct wiring
Specifications
| Brand | MAXXIMA |
|---|
Questions about this item
What bracket clearance is required for the 4 1/8 in height and 4 5/8 in width?
The square head measures 4 1/8 in tall by 4 5/8 in wide with a 3 in depth, so the mounting surface must accommodate those dimensions and the bracket footprint.
How do I connect the blunt-cut wires to a 12/24V DC system?
Strip each wire, match polarity to the vehicle supply, crimp or solder the joints, then seal with heat-shrink or waterproof connectors to maintain the IP67 rating.
When should the sealed LED module be replaced?
The IP67-rated unit is maintenance-free; replace the entire fixture if light output drops below useful levels or the housing is cracked.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
