Maudlin Products
Maudlin Products MSH003 Slotted Shim H-8 8" .003" Pk20
Pack of 20 stainless-steel slotted shims, 8" × 8" × .003" thick, for precise spacing
- TypeShims and Shim Stock
- SizeH-8"x8"
- Precise alignment with ±0.00015 in thickness tolerance
- Consistent fit from ±0.015 in length and width tolerances
- Corrosion-resistant 18-8 stainless steel construction
- Full-hard temper holds shape under load
- Ready-to-use pack of 20 slotted shims
20-piece stainless steel shim pack
This pack contains twenty precision shims made from 18-8 stainless steel with a full-hard temper. Each shim measures eight inches square and is 0.003 inches thick. A 2.5-inch-wide by six-inch-deep slot runs through the centre for bolt clearance. The plain silver finish resists corrosion in industrial environments.
Fit for alignment and spacing tasks
Maintenance technicians and machine builders use these shims to level equipment, set bearing clearances and adjust motor mounts. The tight thickness tolerance of plus or minus 0.00015 inches supports repeatable setups. Buyers who need tabbed shims for easier handling or a different slot geometry should look at another style.
0.003-inch nominal thickness
This dimension determines whether the shim stack achieves the exact gap required. Length and width are each held to ±0.015 inches. The 18-8 stainless material and full-hard temper maintain the thickness under load.
Highlights
- Precise alignment with ±0.00015 in thickness tolerance
- Consistent fit from ±0.015 in length and width tolerances
- Corrosion-resistant 18-8 stainless steel construction
- Full-hard temper holds shape under load
- Ready-to-use pack of 20 slotted shims
Specifications
| Brand | MAUDLIN PRODUCTS |
|---|---|
| Type | Shims and Shim Stock |
| Size | H-8"x8" |
Questions about this item
Will the .003" thickness match the clearance I need on existing H-8 mounts?
Each shim is .003" thick with a tolerance of +/- .00015", so you can stack them to reach the exact gap required on your current hardware.
How do I verify the shims meet the stated tolerances after installation?
Measure the assembled stack with a calibrated micrometer; the combined thickness should fall within the +/- .00015" per shim and length and width within +/- .015".
Does the pack of 20 include any tabs or fasteners, or just the plain stainless shims?
The box contains 20 untabbed slotted shims made of 18-8 stainless steel with a plain finish; no tabs, bolts or adhesive are included.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
