We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black 6.5-inch marine speaker with RGB-lit cone and attachable grille

Matrix

Matrix MRX600B 6.5" 200W 2-Way Marine Speaker Black RGB

SKU CH-4H98-4WBDK

A 6.5-inch 200 W two-way marine speaker with RGB LED cones, 1/2-inch neodymium PEI dome tweeter, water-resistant build and butyl rubber surround

  • 200 W peak power drives loud, clear sound on the water
  • RGB LED cones add customisable colour to every outing
  • 4 Ω impedance and 89 dB sensitivity deliver efficient output from marine amplifiers
  • Water-resistant build with butyl rubber surround withstands spray and salt
  • ½″ neodymium PEI dome tweeter extends high-frequency detail to 20 kHz

Marine Audio Build

The Matrix MRX600B is a 6.5-inch two-way marine speaker system rated at 200 watts maximum power. It features a poly injection cone and a 1/2-inch neodymium PEI dome tweeter for full-range sound on the water. Black grilles are attachable and the cones include RGB LED lighting controlled by a 12-volt remote. The unit is built with water-resistant construction and a butyl rubber surround.

Electrical Interface Limits

The speakers present a 4-ohm impedance and a sensitivity of 89 dB measured at one watt and one metre. Frequency response spans 70 Hz to 20 kHz, so very low bass below 70 Hz will not be reproduced. The magnet structure uses a 22-ounce and 44-ounce combination that requires adequate amplifier current to drive the 200-watt peak rating without clipping.

Pre-Installation Checklist

Verify your amplifier or head unit can deliver clean power into a 4-ohm load at the desired volume level. Confirm a 12-volt supply is available for the RGB remote controller and that the mounting location accommodates a 6.5-inch cut-out with the attachable grille. Ensure wiring is rated for marine environments and that the butyl rubber surround has clearance from any moving parts.

Highlights

  • 200 W peak power drives loud, clear sound on the water
  • RGB LED cones add customisable colour to every outing
  • 4 Ω impedance and 89 dB sensitivity deliver efficient output from marine amplifiers
  • Water-resistant build with butyl rubber surround withstands spray and salt
  • ½″ neodymium PEI dome tweeter extends high-frequency detail to 20 kHz

Specifications

No published specifications for this item yet.

Questions about this item

What power rating should I expect from the MRX600B marine speaker?

The speaker handles 200 watts maximum power with a 4 ohm impedance and 89 dB sensitivity measured at 1 watt and 1 metre.

How low and high does the frequency response reach on this 6.5 inch model?

Frequency response spans 70 Hz to 20 kHz, covering bass through treble for marine audio.

What does the 12 volt RGB remote controller actually drive?

It powers the built-in RGB LED lighted cones on the 6.5 inch 2-way marine speaker system.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.