Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00920644BTC
In stock
Master Lock
Master Lock Non Rekey Padlock Vending and Meter KD
Steel padlock with a 3/8 inch shackle and four-pin cylinder, keyed differently for vending and meter use
- TypeVending and Meter
- Vending and meter padlock fits specific utility enclosures
- Keyed-different system gives each lock its own unique key
- Four-pin cylinder provides basic pick resistance
- Solid steel body and shackle resist cutting attempts
- Non-rekeyable design keeps key control simple and permanent
Master Lock Vending and Meter Padlock
This steel padlock is built for vending machines and utility meters where a simple, keyed-different lock is required. Its rectangular body and 3/8 inch shackle fit standard hasps on coin-operated and metering equipment. The four-pin cylinder uses the Master K1 keyway and cannot be rekeyed.
Upgrade from basic low-security hasp locks
The hardened steel shackle and four-pin cylinder resist casual forcing better than stamped-body padlocks with fewer pins. The jump is worth it when the asset being protected justifies a dedicated, weather-exposed lock that cannot be master-keyed.
Secures single-point vending or meter enclosures
One lock covers one access point; buyers needing multiple keyed-alike units or a master-key system must look elsewhere. The non-rekeyable design means a lost key requires full lock replacement. No weather-resistant rating is claimed, so prolonged outdoor exposure may affect long-term operation.
Highlights
- Vending and meter padlock fits specific utility enclosures
- Keyed-different system gives each lock its own unique key
- Four-pin cylinder provides basic pick resistance
- Solid steel body and shackle resist cutting attempts
- Non-rekeyable design keeps key control simple and permanent
Specifications
| Brand | Master Lock |
|---|---|
| Type | Vending and Meter |
Questions about this item
What shackle diameter does the lock need to fit through the hasp?
The shackle is 3/8 in diameter, so the mounting hole must be at least that wide.
How do I install the padlock on a vending or meter cabinet, and what step is often missed?
Slide the 3/8 in shackle through the hasp and snap the body shut; the step people miss is verifying the shackle fully seats before turning the key.
When will the cylinder or shackle need replacement on this non-rekeyable model?
The 4-pin cylinder cannot be rekeyed; replace the entire padlock if keys are lost or the shackle shows wear.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
