Manw
Manw 6FT 2 Prong 1-15P to Dual C8 Figure 8 AC Power Cord 180 Degree Angle
A 180-degree angled power cord splits one 1-15P wall plug into two C8 figure-8 connectors for laptops and monitors
- 6 ft length reaches distant outlets easily
- 180 degree angle plugs fit tight spaces cleanly
- Dual C8 connectors power two devices simultaneously
- High thermal resistance material handles heat safely
- Non-polarized 1-15P plug works with standard wall sockets
Universal laptop power cord
This 6FT non-polarised cable splits one 1-15P wall plug into two C8 figure-8 connectors, letting you power a pair of laptops or compatible devices from a single outlet. The 180 degree angled plug keeps the cord close to the wall and reduces strain on the socket.
Thermal resistance and power draw
High thermal resistance and high-hardness materials are specified for the jacket, helping the cord withstand heat during normal operation. The design carries standard mains current for typical laptop chargers without excessive voltage drop over the 6FT length.
Dual C8 connector benefit
Supplying two C8 ports from one plug eliminates the need for a separate power strip when charging two devices side by side. The single-cable layout reduces desktop clutter and simplifies cable routing for monitors, lamps or seasonal lighting setups.
Highlights
- 6 ft length reaches distant outlets easily
- 180 degree angle plugs fit tight spaces cleanly
- Dual C8 connectors power two devices simultaneously
- High thermal resistance material handles heat safely
- Non-polarized 1-15P plug works with standard wall sockets
Specifications
| Brand | Manw |
|---|
Questions about this item
How do I plug the 1-15P end into the wall and connect both C8 figure-8 ports without bending the 180 degree angle connectors?
Insert the 2 prong 1-15P plug fully into the outlet, then align each C8 connector with the device inlet and push straight in; the 180 degree angle lets the cable run flat against the wall so the connectors seat without strain.
What wear should I watch for on the dual C8 figure-8 connectors and the 6FT cable jacket over time?
Check the C8 ports for loose fit or discoloured pins and inspect the full 6FT length for cracks or stiffness; replace the cord if either connector wobbles or the jacket shows damage.
At what load does the 15 A rating become the limiting factor during continuous use?
The cord is rated for 15 A; sustained draw near that level will heat the conductors first, so keep the total connected equipment below the rating to avoid thermal stress.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



