Manw
Manw 2 PCS 90 Degree SATA 7Pin Male to Female Adapter
Two 90-degree SATA 7Pin male-to-female data adapters convert straight connectors to right-angle layout for tight chassis routing
- Right-angle design clears tight chassis space with 90° connectors
- Two adapters per pack cover multiple drives cost-effectively
- Pure data path preserves SATA 3.0 6 Gbps throughput
- Compact build fits between motherboard ports and drives easily
- Works with every SATA SSD HDD and optical drive
Two 90° SATA data adapters
This pack contains two 90-degree SATA 7Pin male-to-female adapters that reroute straight data connectors into a right-angle layout. They are intended for desktop builders who need to route data cables cleanly inside compact chassis where straight plugs would press against drive cages or side panels.
Pack of two with SATA 3.0 headroom
Each adapter carries only the seven data pins, so power delivery stays on the existing drive cable while the link runs at full SATA 3.0 6 Gbps speed. The pair covers two drives — typical for a boot SSD plus a storage HDD — and the right-angle bend prevents the cable from kinking in tight bays.
90° right-angle data-only connector
The single deciding specification is the upward 90-degree data-only interface; it adds no power pins and does not convert to eSATA. Buyers who need a straight-through extender, a powered SATA adapter or an eSATA bracket will find this part unsuitable.
Highlights
- Right-angle design clears tight chassis space with 90° connectors
- Two adapters per pack cover multiple drives cost-effectively
- Pure data path preserves SATA 3.0 6 Gbps throughput
- Compact build fits between motherboard ports and drives easily
- Works with every SATA SSD HDD and optical drive
Specifications
| Brand | Manw |
|---|
Questions about this item
Will these 90 degree SATA 7Pin adapters work with my existing SATA III 6Gbps SSD and HDD?
Yes, the adapters fully support SATA 3.0 transmission performance and are universally compatible with all SATA SSD, HDD and optical drives for desktop computers.
How can I verify the adapters are maintaining full SATA 3.0 speed after installation?
Check your BIOS or OS drive information to confirm the connected drives are negotiating at SATA 3.0 6Gbps link speed, which indicates the adapters are passing the signal correctly.
The pack contains two right-angle data adapters — do I need to buy separate SATA data cables to connect my drives?
Yes, these are male-to-female converters that change the connector angle; you still need standard SATA data cables to run between the adapter and each storage drive.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



