We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Four black plastic cable clamps for 32-45mm cables

Manfrotto

Manfrotto 3093 Cable Clamps 32-45mm 4-Pack

SKU CH-XSS6-XNDF0

Four plastic clamps secure cables from 32 to 45 mm diameter to stands or poles, weighing just 0.03 kg each

  • Keeps cables tidy and prevents tripping hazards
  • Fits cable diameters from 32 to 45 mm
  • High-quality plastic withstands daily studio use
  • Weighs only 0.03 kg for easy transport
  • Four clamps included for multiple cable runs

Cable clamps for 32-45 mm cables

The Manfrotto 3093 clamps secure cables with diameters from 32 mm to 45 mm (1.1 to 1.57 inches). Each pack contains four lightweight plastic clamps weighing 0.03 kg in total. They are built for studio and location work where tidy cable runs prevent trips and protect gear. The adjustable grip suits a range of power and data cables used in lighting and camera rigs.

Replaces loose tape or ties

These clamps upgrade from single-use tape, hook-and-loop straps or zip ties that must be cut off for every change. The jump is worth it when you reroute cables daily on stands or truss and need a reusable, non-marring hold that survives repeated setup and teardown. They are not for permanent conduit installs or cables thinner than 32 mm that would slip in the jaws.

Clamps onto poles and stands

Installation is a simple squeeze onto a pole, stand leg or truss chord; the built-in locking tab snaps shut to hold the cable bundle. What usually goes wrong is over-tightening on the smallest cables, which can deform the plastic jaw, or mounting on oversized tubing where the clamp cannot close fully. No tools are required.

Highlights

  • Keeps cables tidy and prevents tripping hazards
  • Fits cable diameters from 32 to 45 mm
  • High-quality plastic withstands daily studio use
  • Weighs only 0.03 kg for easy transport
  • Four clamps included for multiple cable runs

Specifications

No published specifications for this item yet.

Questions about this item

What pole diameter will the 3093 clamps fit on for mounting?

The 3093 clamps are designed for cables measuring 32 to 45 mm in diameter and attach to standard light stands or poles used in studio setups.

How do I install the 3093 clamps on a light stand, and what step is often missed?

Open the clamp, place the cable inside the 32 to 45 mm range, close the hinged jaw, then engage the locking lever fully so the teeth mesh; skipping the lever leaves the cable loose.

When should I replace the 3093 plastic clamps after regular studio use?

Replace any clamp if the hinge pin loosens, the locking teeth wear down, or the plastic shows cracks from repeated tightening on 32 to 45 mm cables.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.