Mag-Mate
Mag-Mate Magnetic Latch Set 13 lb Pull Force
Magnetic latch set holds doors with 13 lb pull force and includes mounting screws
- TypeCabinet & Drawer Hardware
- Strong 13 lb pull keeps cabinets securely closed
- Bright stainless steel finish resists corrosion and looks clean
- Steel and zinc construction handles repeated daily use
- Compact 3/4 by 3/4 inch size fits tight spaces
- Includes screws for quick installation
What the Mag-Mate latch set does
The Mag-Mate magnetic latch set supplies a 13 lb pull force to keep cabinet doors and drawers securely closed. Bright stainless steel catches measure 3/4 in by 3/4 in with a 3/16 in depth for a low profile fit. Pre-drilled center lines sit 1/8 in apart and the kit includes matching screws for a 5/8 in panel hole. Installers and DIYers can add positive latching without visible hardware.
Thermals noise and power draw
This passive hardware has no moving parts, so it generates zero heat and makes no sound during operation. No electrical connection is required, meaning there is no power draw or wiring to plan. The steel and zinc construction resists corrosion in typical indoor environments. Performance stays consistent because nothing wears out or needs lubrication.
What the bundled screws change
Supplied screws match the 5/8 in through-hole size, so the installer does not need to source separate fasteners. Having the correct length and thread pitch prevents stripped holes and misaligned catches. The complete kit reduces trips to the supply aisle and keeps the project on schedule. No additional accessories or software are included.
Highlights
- Strong 13 lb pull keeps cabinets securely closed
- Bright stainless steel finish resists corrosion and looks clean
- Steel and zinc construction handles repeated daily use
- Compact 3/4 by 3/4 inch size fits tight spaces
- Includes screws for quick installation
Specifications
| Brand | MAG-MATE |
|---|---|
| Type | Cabinet & Drawer Hardware |
Questions about this item
How do I install the Mag-Mate magnetic latch with the 1/8 in centre-line prep and 5/8 in panel hole?
Drill a 5/8 in through-hole in the panel, align the latch body so its mounting holes sit on the 1/8 in centre lines, then drive the included screws through the latch into the cabinet or drawer face.
Will the bright stainless steel catch need any lubrication or replacement over time?
The steel/zinc catch with bright stainless finish is corrosion-resistant and has no moving parts to lubricate; it only needs replacement if the 13 lb magnetic pull weakens after years of service.
At what point will the 13 lb pull force stop holding a cabinet door shut?
The latch will release once the applied force exceeds 13 lb, so heavy doors or strong drafts that generate more than that pull will overcome the magnet first.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
