M.A. Ford
M.A. Ford Twister XD 7X+ Coolant Fed Drill 5.40 mm 2XDCL2126A
Coolant-fed drill bit creates 5.40 mm holes with internal lubrication delivery
- Coolant-fed design removes heat for longer tool life
- 40 mm diameter suits precise drilling tasks
- 7X+ geometry boosts cutting efficiency in tough materials
- Twister XD construction resists wear during heavy use
- California Prop 65 notice informs safe handling practices
M.A. Ford Twister XD 7X+ Drill
The M.A. Ford Twister XD 7X+ is a coolant-fed drill bit manufactured for precision holemaking. It is engineered for professional machinists and maintenance technicians who require reliable performance in demanding metalworking applications. The 5.40 mm cutting diameter suits specific pilot-hole and through-hole requirements. This new tool arrives directly from the manufacturer.
Suited for coolant-fed drilling operations
This drill suits workshops equipped with machine tools that deliver coolant through the spindle. It is not intended for hand-held drilling or machines lacking through-coolant capability. Buyers who need a standard twist drill without internal coolant channels should look at a different product. The design targets high-efficiency chip evacuation in deep-hole drilling tasks.
5.40 mm diameter for targeted hole sizes
The 5.40 mm diameter handles specific fastener clearance or tap-drill sizes in metal components. It runs out when the application requires a larger or smaller nominal diameter than the fixed 5.40 mm specification. The 7X+ designation indicates extended reach for deeper holes relative to standard-length drills. California Proposition 65 warnings apply to chemicals present in the product.
Highlights
- Coolant-fed design removes heat for longer tool life
- 40 mm diameter suits precise drilling tasks
- 7X+ geometry boosts cutting efficiency in tough materials
- Twister XD construction resists wear during heavy use
- California Prop 65 notice informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What machine spindle is required to run the 2XDCL2126A drill?
The 2XDCL2126A has a straight shank that fits standard drill chucks or collet holders on milling machines and CNC centres.
Can the 5.40 mm Twister XD 7X+ replace an older 5.40 mm cobalt drill in the same holder?
Yes, the 5.40 mm diameter and straight shank match the older drill, so the same holder works without change.
How do I confirm the coolant-fed 2XDCL2126A is delivering fluid correctly after installation?
Start the spindle at low speed, engage coolant, and verify a steady stream exits the drill tip before beginning the cut.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
