M.A. Ford
M.A. Ford Twister Xd 5X Solid Carbide Drill 9.30 mm
A 9.30 mm solid carbide drill built for 5× depth drilling in demanding applications
- Solid carbide construction resists wear for longer tool life
- 5X diameter drilling depth reaches deeper holes in one pass
- 30 mm diameter suits precise metric hole requirements
- Twister Xd geometry improves chip evacuation during drilling
- California Proposition 65 warning informs safe handling practices
9.30 mm Twister Xd 5X drill
The M.A. Ford Twister Xd 5X is a solid carbide drill bit with a 9.30 mm cutting diameter. It is designed for precision drilling in demanding materials where tool rigidity and wear resistance are critical. Professional machinists and maintenance engineers select it for high-performance holemaking in tough alloys. The solid carbide construction supports consistent accuracy across repeated operations.
Stepping up from standard HSS tooling
This drill replaces conventional high-speed steel or cobalt bits when longer tool life and higher cutting speeds are required. The jump is worth it when machining hardened steels, stainless alloys or high-temperature materials that dull lesser tooling quickly. Its 5X diameter flute length allows deeper holes in a single pass. Shops staying with HSS for these materials face frequent changes and lost productivity.
Limits of solid carbide in handheld use
Solid carbide is brittle and will fracture under side loads or vibration common in handheld drilling. The tool demands a rigid machine spindle, secure workholding and proper coolant delivery to reach its potential. It is not suited for manual drill presses lacking runout control or for interrupted cuts. Users without rigid CNC setups should consider tougher substrate alternatives.
Highlights
- Solid carbide construction resists wear for longer tool life
- 5X diameter drilling depth reaches deeper holes in one pass
- 30 mm diameter suits precise metric hole requirements
- Twister Xd geometry improves chip evacuation during drilling
- California Proposition 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank size does the 9.30 mm Twister Xd 5X drill use?
The drill has a straight shank matching its 9.30 mm cutting diameter, so it fits any three-jaw chuck or collet that opens to at least 9.30 mm.
What is the most common installation mistake with this solid-carbide drill?
Running it without adequate coolant or peck cycles; the 5× length-to-diameter ratio makes chip evacuation critical, so use flood coolant and programmed pecks to prevent breakage.
When should the 9.30 mm Twister Xd 5X drill be replaced?
Replace it when flank wear reaches 0.3 mm, when the corner radius chips, or when hole diameter exceeds tolerance — solid carbide cannot be economically resharpened at this size.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
