M.A. Ford
M.A. Ford Twister Xd 5X Solid Carbide Drill 9.20Mm 2XDSR3622A
A solid carbide drill bit with a 9.20 mm diameter for high-performance drilling applications
- Solid-carbide construction resists wear for longer tool life
- 5× diameter reach drills deeper holes in one pass
- 20 mm diameter matches precise hole requirements
- Twister XD geometry improves chip evacuation while cutting
- California Proposition 65 warning discloses regulated chemical content
Solid carbide drill 9.20 mm
This 9.20 mm solid carbide drill is built for high-speed drilling in steel, stainless steel and cast iron. The Twister Xd 5X geometry keeps chips short and evacuation clean, so machinists and tool-room technicians can run deeper holes without pecking.
Five-times-diameter flute length
The flute length is five times the 9.20 mm diameter, giving a single-pass drilling depth that standard jobber drills cannot reach. Buyers who need longer reach or a different diameter will need another tool.
Straight-shank fit for standard holders
The plain cylindrical shank drops into any ER collet, hydraulic chuck or three-jaw holder without adapters. Problems arise when the holder run-out exceeds a few microns, as carbide will chip instead of deflecting.
Highlights
- Solid-carbide construction resists wear for longer tool life
- 5× diameter reach drills deeper holes in one pass
- 20 mm diameter matches precise hole requirements
- Twister XD geometry improves chip evacuation while cutting
- California Proposition 65 warning discloses regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What hole depth can the 9.20 mm Twister Xd 5X drill reach in a single pass?
The five-times-diameter design allows drilling up to five times the 9.20 mm diameter in one pass, so the practical depth limit is set by that ratio and your machine travel.
What shank standard does the 2XDSR3622A use and what does it limit?
It uses a standard cylindrical shank that fits common drill chucks and collets; the shank diameter caps the maximum holder capacity you can use.
What physical clearance does the 9.20 mm solid carbide drill need to fit in my setup?
You need enough spindle travel for the full flute length plus shank engagement, and a holder that accepts the drill’s shank diameter without interference.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
