M.A. Ford
M.A. Ford Twister Xd 5X Solid Carbide Drill 7.30Mm
A 7.30 mm solid carbide drill bit for high-performance drilling applications
- 30 mm diameter fits precise drilling tasks
- Twister Xd 5X geometry supports five-times-diameter depth
- Solid carbide construction resists wear in tough materials
- M.A. Ford brand signals professional-grade tooling
- California Proposition 65 warning informs safe handling practice
M.A. Ford Twister Xd 5X Solid Carbide Drill
The M.A. Ford Twister Xd 5X is a solid carbide drill bit manufactured to a 7.30 mm diameter. It is designed for high-performance drilling in demanding industrial applications where tool rigidity and wear resistance are critical.
Suited for precision drilling in tough materials
This drill suits machinists and fabricators who require a rigid, long-lasting tool for producing accurate 7.30 mm holes in hardened alloys or abrasive composites. It is not intended for hand-held use in soft woods or plastics where a high-speed steel bit would be more appropriate and cost-effective.
7.30 mm cutting diameter
The 7.30 mm diameter is the primary specification that determines fit for a specific hole size or tap drill requirement. Verify this exact measurement against your engineering drawing or thread chart before ordering to ensure compatibility with the intended fastener or operation.
Highlights
- 30 mm diameter fits precise drilling tasks
- Twister Xd 5X geometry supports five-times-diameter depth
- Solid carbide construction resists wear in tough materials
- M.A. Ford brand signals professional-grade tooling
- California Proposition 65 warning informs safe handling practice
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size collet or chuck is required to hold the 7.30 mm shank of this Twister Xd drill?
A 7.30 mm capacity collet or three-jaw chuck is needed; the drill shank matches that diameter exactly.
Can the 2XDSR2874A be used in a standard drill press alongside older high-speed steel bits?
Yes, it fits any machine with a 7.30 mm chuck, but run it at carbide-appropriate speeds and feed rates rather than HSS settings.
How can I confirm the 5X solid carbide drill is cutting correctly after installation?
Check for a straight, round 7.30 mm hole with consistent chip evacuation and no chatter marks at the recommended feed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
