M.A. Ford
M.A. Ford Twister XD 5X Solid Carbide Drill 5.90 mm 2XDSR2323A
Solid carbide drill bit for 5.90 mm holes, built for extended tool life
- Solid carbide construction delivers long tool life
- 5X diameter design enables deep-hole drilling
- 90 mm diameter suits precise hole sizing
- Twister XD geometry improves chip evacuation
- M.A. Ford brand trusted by professionals
M.A. Ford Twister XD 5.90 mm drill
The M.A. Ford Twister XD 5X is a solid carbide drill bit measuring 5.90 mm. It belongs to the Power & Pneumatic Accessories category for automotive and tool use. The item is supplied new and ships directly from the manufacturer. This drill suits professionals creating precise holes in tough materials.
Sustained drilling with solid carbide
Solid carbide construction maintains cutting geometry during extended drilling cycles. The 5X design supports deeper holes without frequent pecking cycles. Heat resistance reduces edge breakdown when feed rates stay consistent. The tool avoids the deflection common in high-speed steel under continuous load.
Shank fit and safety notices
The straight shank fits standard drill chucks and collet holders used in workshop machines. Secure clamping prevents runout that would damage the carbide tip. California Proposition 65 warnings apply for cancer and reproductive harm risks. Users should follow handling guidelines for carbide dust and coolant exposure.
Highlights
- Solid carbide construction delivers long tool life
- 5X diameter design enables deep-hole drilling
- 90 mm diameter suits precise hole sizing
- Twister XD geometry improves chip evacuation
- M.A. Ford brand trusted by professionals
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How much heat does the 5.90 mm Twister XD 5X generate during continuous drilling?
The solid carbide construction dissipates heat efficiently, but prolonged high-speed use will warm the shank; use cutting fluid and allow cooling pauses to manage temperature.
What tool holder or chuck is required to run the 2XDSR2323A?
A standard drill chuck or collet that accepts a 5.90 mm shank is needed; ensure the holder provides firm, concentric grip for carbide tooling.
Will the 5.90 mm carbide drill work reliably in an older pillar drill with run-out?
Carbide is brittle; excessive spindle run-out on older machines can chip the cutting edges, so verify run-out is minimal before use.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
