M.A. Ford
M.A. Ford Twister XD 5X Solid Carbide Drill 3.70mm
Solid carbide drill bit creates precise 3.70mm holes in tough materials
- Solid carbide construction resists wear for longer tool life
- 5× diameter flute length reaches deeper holes in one pass
- 70 mm cutting diameter matches precise drilling requirements
- Twister XD geometry improves chip evacuation during operation
- M.A. Ford manufacturing delivers consistent performance in power tool applications
Drill 3.70 mm
M.A. Ford Twister XD 5X is a solid carbide drill built for high-performance drilling in demanding materials. The 3.70 mm diameter suits precise hole-making in metalworking and automotive applications. New condition ensures full tool life from the first use.
Target users
Machinists and fabricators who need a rigid, wear-resistant drill for tough alloys will benefit from the solid carbide construction. Buyers who require a larger diameter or a different flute geometry should look at alternative tooling. The drill is not suited for hand-held use without a rigid setup.
Key spec
The 3.70 mm cutting diameter is the single specification that decides fit for the hole size required. Verify the diameter matches the job before ordering. California Proposition 65 warnings apply to this product.
Highlights
- Solid carbide construction resists wear for longer tool life
- 5× diameter flute length reaches deeper holes in one pass
- 70 mm cutting diameter matches precise drilling requirements
- Twister XD geometry improves chip evacuation during operation
- M.A. Ford manufacturing delivers consistent performance in power tool applications
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 3.70 mm carbide drill generate noticeable heat during extended use?
The solid carbide construction dissipates heat efficiently, keeping the 3.70 mm drill cool even during long drilling sessions.
What power tool is required to run the Twister XD 5X drill?
A standard drill press or handheld drill with a 3.70 mm chuck capacity will drive this bit.
Will the 3.70 mm bit fit in my older drill press chuck?
Yes, the 3.70 mm shank fits any chuck that accepts 3.70 mm or larger diameters.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
