M.A. Ford
M.A. Ford Twister Xd 5X Solid Carbide Drill 14.70mm 2XDSR5787A
Solid carbide Twister Xd drill cuts 14.70 mm holes at 5× diameter depth
- 70 mm diameter suits precise drilling tasks
- Twister Xd 5X design supports efficient material removal
- Solid carbide construction resists wear in tough materials
- M.A. Ford brand delivers professional-grade tool reliability
- California Prop 65 notice flags chemical safety awareness
Product identity
The M.A. Ford Twister Xd 5X is a solid carbide drill bit measuring 14.70 mm in diameter. It belongs to the Power & Pneumatic Accessories range and is aimed at professional machinists and maintenance teams who need reliable hole-making in tough materials.
Upgrade path
The drill replaces worn or lower-grade carbide tooling when hole quality and tool life become critical. The jump is worth it when existing bits cannot hold tolerance or when cycle times must be reduced on hardened alloys.
Installation notes
The bit fits standard tool holders that accept a 14.70 mm shank, so setup is a direct swap in most CNC or manual drilling stations. The main risk is running without proper coolant flow, which can cause premature flank wear or catastrophic breakage. California Proposition 65 warnings apply because the product contains listed chemicals.
Highlights
- 70 mm diameter suits precise drilling tasks
- Twister Xd 5X design supports efficient material removal
- Solid carbide construction resists wear in tough materials
- M.A. Ford brand delivers professional-grade tool reliability
- California Prop 65 notice flags chemical safety awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size chuck or collet is required for the 14.70 mm shank?
Use a 14.70 mm collet or a chuck that opens to at least 14.70 mm for a secure grip.
How should the Twister Xd 5X drill be installed in the holder to avoid run-out?
Seat the shank fully, tighten the collet evenly, and verify concentricity before starting the spindle.
When should the 14.70 mm solid carbide drill be replaced?
Replace it when flank wear reaches the manufacturer's limit or when hole quality and dimensional tolerance fall out of spec.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
