M.A. Ford
M.A. Ford Twister Xd 5X Coolant Fed Drill No 31
A Twister Xd 5X coolant-fed drill in size No 31 for high-performance drilling applications
- Twister Xd design drills five times diameter depth
- Coolant-fed operation clears chips for cleaner holes
- Size 31 suits precise drilling applications
- M.A. Ford engineering delivers reliable cutting performance
- California Proposition 65 warning notes chemical exposure risk
M.A. Ford Twister Xd Drill No 31
The M.A. Ford Twister Xd 5X Coolant Fed Drill No 31 is a new cutting tool built for precision hole-making in demanding materials. Its coolant-fed design delivers fluid directly to the cutting zone for improved chip evacuation and extended tool life. This drill suits machine-shop professionals who require consistent performance on CNC equipment.
Buyers needing high-volume production
This drill fits operations that run 5× diameter depth holes and rely on internal coolant delivery for heat control. Shops without through-spindle coolant systems or those drilling shallow holes only will not benefit from the specialised geometry. The Proposition 65 notice also means facilities with strict chemical-exposure policies must review compliance before purchase.
5× diameter coolant-fed drilling depth
The defining specification is the 5× diameter drilling capacity combined with internal coolant feed. This ratio determines whether the tool reaches the required depth in a single pass without peck cycles. Verify the workpiece thickness and machine coolant pressure match this capability before ordering.
Highlights
- Twister Xd design drills five times diameter depth
- Coolant-fed operation clears chips for cleaner holes
- Size 31 suits precise drilling applications
- M.A. Ford engineering delivers reliable cutting performance
- California Proposition 65 warning notes chemical exposure risk
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What machine spindle and coolant system do I need to run the 2XDCR1200A Twister Xd 5X drill?
The drill requires a spindle that accepts its shank and a machine capable of delivering coolant through the tool at the pressure your application demands.
Can I use the No 31 Twister Xd drill in a setup that currently runs older non-coolant-fed drills?
You can swap it in if the holder matches the shank, but the machine must supply through-tool coolant; otherwise the drill will not perform as designed.
How do I confirm the 2XDCR1200A is cutting correctly after installation?
Check for steady chip evacuation through the flutes, consistent hole diameter at the No 31 size, and no discolouration on the cutting edges during the first holes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
