M.A. Ford
M.A. Ford Twister Xd 5X Coolant Fed Drill 2XDCR3320A Q
Coolant-fed Twister Xd drill with 5X reach, model 2XDCR3320A, for deep-hole drilling
- 5x coolant-fed drilling for efficient chip removal
- Twister XD design for high-performance drilling
- M.A. Ford quality for professional applications
- Model 2XDCR3320A identifies exact specification
- California Proposition 65 chemical warning applies
Application and design
This Twister Xd drill is a coolant-fed cutting tool built for production drilling where through-tool lubrication improves chip evacuation and tool life. The 5× diameter length suits deeper holes in a single pass. It is aimed at machine shops and maintenance teams that run CNC or dedicated drilling units and need consistent performance in steel, cast iron and similar materials.
Who it suits and who it does not
Shops that have coolant-through spindles and run high-volume drilling cycles will benefit from the internal coolant channel. Operations without through-coolant capability, or those that only drill shallow holes by hand, will not use the feed feature and should consider a standard solid drill instead.
Critical specification
The 5× diameter flute length is the single figure that decides fit: it sets the maximum drill depth per engagement and determines whether the tool clears the workpiece without pecking. Verify that your machine spindle and holder accept the shank and that the programmed depth matches this length before ordering.
Highlights
- 5x coolant-fed drilling for efficient chip removal
- Twister XD design for high-performance drilling
- M.A. Ford quality for professional applications
- Model 2XDCR3320A identifies exact specification
- California Proposition 65 chemical warning applies
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How is the M.A. Ford Twister Xd 5X Coolant Fed Drill installed and what step do operators often miss?
Mount the drill in a rigid holder, align the coolant port with the machine supply, then lock the collet. The step most often missed is verifying coolant flow through the internal channels before the first cut.
What maintenance or replacement will the 2XDCR3320A drill need later?
Inspect the cutting edges after each job; resharpen or replace the drill when flank wear reaches the limit. Flush the coolant passages weekly to prevent blockage from swarf buildup.
What limit appears first on the Twister Xd drill during sustained high-feed drilling?
The internal coolant passages clog with fine swarf before the carbide substrate overheats, forcing an unplanned stop to clear the tool.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
