M.A. Ford
M.A. Ford Twister Xd 3X Solid Carbide Drill 9.80 mm
Solid carbide drill bit with 9.80 mm diameter for high-precision drilling tasks
- Solid carbide construction resists wear for longer tool life
- 3X flute design improves chip evacuation during drilling
- 80 mm diameter suits precise hole-making tasks
- M.A. Ford manufacturing delivers consistent cutting performance
- California Proposition 65 warning indicates regulated substance presence
Twister Xd 3X Solid Carbide Drill
The M.A. Ford Twister Xd 3X is a solid carbide drill bit manufactured to a 9.80 mm diameter. It is designed for machining operations that demand high rigidity and wear resistance from a single-piece carbide construction. Professional machinists and maintenance teams select this tool for precision hole-making in tough alloys and hardened materials.
Upgrade from standard HSS or 2XD series
This drill replaces conventional high-speed steel bits and earlier 2XD designs when longer tool life and higher cutting speeds are required. The jump is justified when cycle-time reduction and consistent hole quality outweigh the higher upfront cost of solid carbide. It is not suited for hand-held drilling or unstable setups that risk carbide fracture.
Sustained-load behaviour in production runs
Under continuous production loading the solid carbide body maintains dimensional stability and resists heat-related wear better than cobalt or HSS alternatives. The 3X geometry supports efficient chip evacuation at recommended feeds, reducing the likelihood of built-up edge during extended cuts. California Proposition 65 warnings apply to this product.
Highlights
- Solid carbide construction resists wear for longer tool life
- 3X flute design improves chip evacuation during drilling
- 80 mm diameter suits precise hole-making tasks
- M.A. Ford manufacturing delivers consistent cutting performance
- California Proposition 65 warning indicates regulated substance presence
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What chuck size is required for the 9.80 mm shank?
Use a drill chuck or collet that accepts a 9.80 mm shank. Ensure the jaws grip the full shank length without over-tightening, which can distort the carbide.
How do I mount the Twister Xd 3X drill correctly?
Insert the shank fully into the chuck, align the drill axis with the workpiece, and start at low RPM to centre the point before increasing speed. The common error is engaging high RPM before the tip seats.
When should the 9.80 mm solid carbide drill be replaced?
Replace the drill when flank wear reaches the margin, the cutting edges chip, or hole diameter drifts beyond tolerance. Solid carbide cannot be economically resharpened on site.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
