M.A. Ford
M.A. Ford Twister Xd 3X Solid Carbide Drill 9.50Mm
Solid carbide drill bit with 3x diameter flute length for 9.50 mm holes
- Solid carbide construction resists wear for longer tool life
- Twister Xd 3X geometry improves chip evacuation during drilling
- 50 mm diameter suits precise hole-making tasks
- M.A. Ford brand delivers professional-grade cutting performance
- California Proposition 65 warning informs safe handling practices
M.A. Ford Twister Xd 3X 9.50Mm Drill
The M.A. Ford Twister Xd 3X is a solid carbide drill with a 9.50Mm diameter designed for high-performance drilling. It belongs to the Power & Pneumatic Accessories category and is supplied new from the manufacturer. This cutting tool is built for precision hole-making in demanding industrial applications.
Suited for CNC and high-precision work
This drill suits machinists and engineers running CNC equipment who need consistent hole quality in tough materials. It is not intended for hand-held drilling or low-rigidity setups where run-out would damage the carbide. Buyers needing larger diameters or different lengths must select alternative tooling.
9.50Mm diameter with 3X depth capability
The 9.50Mm cutting diameter provides a specific hole size for downstream operations such as tapping or reaming. The 3X design allows drilling depths up to three times the diameter in a single pass. It runs out when hole depths exceed this ratio or when workpiece rigidity cannot support the required feed rates.
Highlights
- Solid carbide construction resists wear for longer tool life
- Twister Xd 3X geometry improves chip evacuation during drilling
- 50 mm diameter suits precise hole-making tasks
- M.A. Ford brand delivers professional-grade cutting performance
- California Proposition 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Do I need a drill chuck that accepts a 9.50 mm shank to use this Twister Xd?
Yes — the drill has a 9.50 mm diameter, so your chuck or collet must grip that size securely.
Will the 3X solid carbide design cut the same materials as the high-speed steel bits I already own?
Carbide is harder and more heat-resistant than HSS, so it will handle tougher alloys, but it is more brittle and needs rigid clamping.
How can I verify the 2XDSS3740A drill is cutting correctly after I install it?
Check for a smooth, round hole at 9.50 mm diameter with minimal burr and listen for a steady cutting sound without chatter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
