M.A. Ford
M.A. Ford Twister Xd 3X Solid Carbide Drill 9.25Mm 2XDSS3642A
A solid-carbide Twister Xd drill cuts 9.25 mm holes with 3× diameter reach
- Solid carbide construction resists wear for longer tool life
- Twister Xd 3X geometry improves chip evacuation in deep holes
- 25 mm diameter suits precise drilling applications
- M.A. Ford manufacturing delivers consistent cutting performance
- New condition ensures full factory specification out of the box
Twister Xd 3X Solid Carbide Drill
The M.A. Ford Twister Xd 3X is a solid carbide drill built for precision holemaking in demanding materials. Its 9.25 mm cutting diameter suits machine shops and maintenance teams that require consistent accuracy. The 3X flute geometry promotes efficient chip evacuation during deep drilling cycles. This accessory targets professionals who prioritise tool life and hole quality over disposable alternatives.
Upgrading from standard twist drills
Conventional high-speed steel drills wear quickly in hardened steels and abrasive alloys, forcing frequent tool changes. The solid carbide construction maintains cutting edges longer, reducing downtime on CNC centres and manual mills. The jump is justified when hole tolerance and surface finish must stay within tight bands across a full production run. Shops drilling softer aluminium or low-volume batches may not recover the higher upfront cost.
Sustained cutting performance
Under continuous load the carbide substrate resists heat buildup better than cobalt or HSS equivalents, keeping flank wear predictable. The 3X design stabilises the drill point, limiting walk-off during extended engagement in tough alloys. Operators see steady torque draw rather than spikes caused by chip packing. The tool is not suited for hand-held use where rigidity and coolant control cannot be maintained.
Highlights
- Solid carbide construction resists wear for longer tool life
- Twister Xd 3X geometry improves chip evacuation in deep holes
- 25 mm diameter suits precise drilling applications
- M.A. Ford manufacturing delivers consistent cutting performance
- New condition ensures full factory specification out of the box
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter does the 9.25 mm Twister Xd 3X drill need for a secure fit?
The shank matches the 9.25 mm cutting diameter, so a 9.25 mm collet or chuck is required for proper clamping.
How should the 2XDSS3642A drill be installed to avoid premature wear?
Clamp the shank fully into a clean, precision collet with minimal overhang; the step often missed is verifying true runout before the first plunge.
When will the solid carbide 9.25 mm drill need replacement?
Replace it once the cutting edges show chipping or the corner radius wears beyond a sharp edge — solid carbide cannot be economically resharpened.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
