M.A. Ford
M.A. Ford Twister Xd 3X Solid Carbide Drill 7.50 mm
A 7.50 mm solid carbide drill bit for high-precision drilling applications
- Solid carbide construction resists wear during high-speed drilling
- Twister Xd 3X geometry improves chip evacuation in deep holes
- 50 mm diameter matches standard metric tap sizes
- M.A. Ford manufacturing ensures consistent hole quality
- California Proposition 65 warning discloses regulated chemical content
Application
The M.A. Ford Twister Xd 3X is a solid carbide drill bit sized at 7.50 mm. It serves machinists and maintenance teams who need a rigid tool for producing accurate holes in steel, cast iron and similar alloys. The 3X geometry supports deeper drilling without frequent pecking. Buyers who require a larger diameter or a coolant-fed shank will need a different tool.
Tool life
Solid carbide construction resists wear and heat better than high-speed steel, so the cutting edges stay sharp longer during repeated cycles. The 3X flute design helps evacuate chips efficiently, reducing friction and the risk of work hardening. No coolant-through passages are present, so external flood or mist cooling must be supplied for demanding cuts.
Diameter
The drill diameter is 7.50 mm, which fixes the hole size this bit can produce. Verify that your machine spindle and holder accept this shank before ordering. The manufacturer part reference 2XDSS2953A identifies this exact specification.
Highlights
- Solid carbide construction resists wear during high-speed drilling
- Twister Xd 3X geometry improves chip evacuation in deep holes
- 50 mm diameter matches standard metric tap sizes
- M.A. Ford manufacturing ensures consistent hole quality
- California Proposition 65 warning discloses regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 7.50 mm Twister Xd drill bit in my drill press and what step is often missed?
Secure the 7.50 mm shank fully in the chuck jaws, tightening each jaw evenly; the step most often missed is verifying zero run-out with a dial indicator before cutting.
What maintenance or replacement will the solid carbide 2XDSS2953A drill need over time?
The solid carbide body cannot be resharpened conventionally; once the cutting edges dull, the entire 7.50 mm drill must be replaced.
What limit appears first when the Twister Xd 3X drill runs continuously in steel?
Heat buildup at the 7.50 mm cutting edges is the first limiting factor; without adequate coolant the carbide will overheat and lose hardness rapidly.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
